Mercedes-Benz E43 AMG Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5,558)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5,558)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz E43 AMG Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2018 Mercedes-Benz E43 AMGV6-3.0L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2017 Mercedes-Benz E43 AMGV6-3.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mercedes-Benz E43 AMG Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5,558)

Rating Summary
5,170
189
54
28
117
5,170
189
54
28
117

William

33 years of experience
69 reviews
William
33 years of experience
Mercedes-Benz E350 V6-3.5L - Reduced Power light is on - Sun City, California
Excellent customer service. Patient as well. Highly recommended.

Chris

16 years of experience
325 reviews
Chris
16 years of experience
Mercedes-Benz C230 V6-2.5L - Oil/Fluid Leak - San Diego, California
It was reassuring to know exactly what is wrong with my vehicle prior to going to the dealership. Having an idea of what and how much to expect, Chris gave me that.

Chuck

45 years of experience
22 reviews
Chuck
45 years of experience
Mercedes-Benz GLK350 V6-3.5L - Oil Change - Morganville, New Jersey
...

Edmar

22 years of experience
246 reviews
Edmar
22 years of experience
Mercedes-Benz GL450 V8-4.6L - Mass Airflow Sensor Replacement - The Colony, Texas
BEST JOB I EVERY HAD THANKS

Excellent Rating

(5,558)

Rating Summary
5,170
189
54
28
117
5,170
189
54
28
117
Number of Mercedes-Benz services completed
61138+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Buy a Good Quality Radiator
The The numerous moving parts of a vehicle are certain to rub together, causing friction which generates a generous amount of heat. The motor oil that is being pumped in as lubrication can only do so much – it can’t...
How to Buy a Car
Buying a new car is a major event. For many people a car is the most expensive thing they will buy. Pick the right type of car to suit your needs.
B1999 OBD-II Trouble Code: Passenger Side Side-Mount Air Bag Low Resistance on Squib
B1999 trouble code means there's a circuit malfunction in the passenger side-mount air bag inflator, caused by blown fuses or shorted wires.

Is engine permanently - VW GTI oil screen fell out and intake camshaft,bridge and timing chain and tensioner had to be replaced.

Failure of the screen in the cam bridge that you are referring to is not uncommon. Indeed, the OEM bridge was updated and presumably that (the update) was installed in your vehicle. So long as all oil passages were clear...

Hello. I replaced the crankshaft position sensor on my dodge avenger and now it won't start.

Id like an advice on what ways i can re program

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com