Jeep J-4500 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(18)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(18)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Jeep J-4500 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1972 Jeep J-4500V8-5.9LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1970 Jeep J-4500L6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1971 Jeep J-4500V8-5.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1971 Jeep J-4500L6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1973 Jeep J-4500V8-5.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1972 Jeep J-4500L6-4.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1972 Jeep J-4500V8-5.0LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1970 Jeep J-4500V8-5.3LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Jeep J-4500 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Jeep mechanics

Real customer reviews from Jeep owners like you.

Excellent Rating

(18)

Rating Summary
17
1
0
0
0
17
1
0
0
0

Ira

36 years of experience
259 reviews
Ira
36 years of experience
Jeep Cherokee L6-4.0L - Car starts and then dies - Tampa, Florida
arrived early went straight to work figured out the problems and relayed the info well....will use again

Johnny

33 years of experience
267 reviews
Johnny
33 years of experience
Jeep Grand Cherokee V6-3.7L - Car starts and then dies - North Highlands, California
Very friendly.

Ramiro

21 years of experience
73 reviews
Ramiro
21 years of experience
Jeep Wrangler L6-4.0L - Car starts and then dies - Seattle, Washington
On time was thorough and did a great job

Matthew

33 years of experience
1229 reviews
Matthew
33 years of experience
Jeep Grand Cherokee L6-4.0L - Car starts and then dies - Norfolk, Virginia
Knowlegable

Excellent Rating

(18)

Rating Summary
17
1
0
0
0
17
1
0
0
0
Number of Jeep Car starts and then dies Inspection services completed
198+
services done by our mechanics
TOTAL NUMBER OF EXPERT Jeep MECHANICS
1300+
experts on our platform

Recent articles & questions

The Best Used Cars to Buy If You Just Retired
Here’s Here’s a cruel, hard fact – car manufacturers no longer target seniors. Instead, they devote their time and energy to appealing to the 18-45 demographic. Still, some features make certain cars more suitable for older drivers. We have evaluated...
Symptoms of a Bad or Faulty Door Lock Switch
If the door locks are not functioning well or the door lock button is broken, you may need to replace the door lock switch.
B2101 OBD-II Trouble Code: Head Rest Switch Circuit Failure
B2101 trouble code means there's a malfunction with the power headrest switch circuit, caused by faulty components in the headrest switch or headrest.

I would like to know what can be causing my coolant to drain quickly to the point where i have to re fill it every 2 days no leaks

There is a leak (https://www.yourmechanic.com/article/how-to-diagnose-a-fluid-leak-by-mark-vallet) somewhere and if there is no leak, from an external source, then the engine is leaking internally. My recommendation is to have a coolant pressure test and a combustion leakage check on the radiator (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-radiator)....

1994 Chevrolet Silverado extended cabV-8 oil pan gasket replacement?

Hi there. You would have to drain the engine oil out of the oil pan, put the plug back in the oil pan, and remove the oil pan bolts to take the pan off. Once the pan is off, you...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com