Dodge B200 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(4)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(4)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Dodge B200 Car starts and then dies Inspection is $105 with $0 for parts and $105 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1975 Dodge B200L6-3.7LService typeCar starts and then dies InspectionEstimate$124.99Shop/Dealer Price$133.39 - $139.69
1980 Dodge B200V8-5.2LService typeCar starts and then dies InspectionEstimate$104.99Shop/Dealer Price$113.41 - $119.72
1976 Dodge B200V8-7.2LService typeCar starts and then dies InspectionEstimate$104.99Shop/Dealer Price$113.41 - $119.72
1977 Dodge B200V8-5.9LService typeCar starts and then dies InspectionEstimate$104.99Shop/Dealer Price$113.39 - $119.68
1978 Dodge B200V8-6.6LService typeCar starts and then dies InspectionEstimate$104.99Shop/Dealer Price$113.42 - $119.75
1976 Dodge B200V8-5.2LService typeCar starts and then dies InspectionEstimate$104.99Shop/Dealer Price$113.41 - $119.72
1978 Dodge B200V8-5.9LService typeCar starts and then dies InspectionEstimate$124.99Shop/Dealer Price$130.87 - $135.28
1978 Dodge B200V8-5.2LService typeCar starts and then dies InspectionEstimate$124.99Shop/Dealer Price$131.24 - $135.94
Show example Dodge B200 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Dodge mechanics

Real customer reviews from Dodge owners like you.

Excellent Rating

(4)

Rating Summary
3
1
0
0
0
3
1
0
0
0

Napoleon

27 years of experience
147 reviews
Napoleon
27 years of experience
Dodge B200 * - Car is not starting - Redondo Beach, California
Thank you very much. Napoleon showed up on time and did a wonderful job. I hope he is my mechanic next time I call. Thanks again !! :-)

Brian

24 years of experience
208 reviews
Brian
24 years of experience
Dodge B200 V8-5.9L - Car is not starting - Hanover, Pennsylvania
Brian worked very methodically to narrow down the problem I had. It was a starting issue. It seems as though the distributor is the culprit, but I won't know if that is the answer until I replace it with a new one. Brian gave me his phone number to inform him of the results of his diagnosis...He is a pleasure to work with.

Jay

37 years of experience
968 reviews
Jay
37 years of experience
Dodge B200 V8-5.2L - Fuel is leaking from gas tank - Grand Terrace, California
Jay was Awesome was happy you sent him !!!hope he finishes the job when get my part !

Jason

32 years of experience
537 reviews
Jason
32 years of experience
Dodge B200 V8-5.2L - Brakes, Steering and Suspension Inspection - San Jose, California
Very patient, kind and considerate. Answered all my questions in a simple way that I could understand. I will always request Jason. Even if he is booked for 2 weeks. I will wait for him to become available. He is worth waiting for. Professional, Competent, Expert, Knowledgable, Goes above and beyond, Friendly, Courteous and Timely.

Excellent Rating

(4)

Rating Summary
3
1
0
0
0
3
1
0
0
0
Number of Dodge B200 services completed
44+
services done by our mechanics
TOTAL NUMBER OF EXPERT Dodge MECHANICS
1400+
experts on our platform

Recent articles & questions

Top 10 Scenic Drives in Southern California
Southern California has some of the most diverse landscape and terrain in the world, and this makes it an ideal region to explore by way of a scenic drive. Over the course of an hour, afternoon, or even a weekend,...
Why Washing Your Car in Winter is Important
Keeping your car clean in winter makes your car last longer. Wash your car in winter to prevent rust under your car and keep ice off your windshield.
P2067 OBD-II Trouble Code: Fuel Level Sensor B Circuit Low
P2067 P2067 code definition? Fuel Level Sensor B Circuit Low What the P2067 code means The Engine Control Module (ECM) utilizes a sensor either built into the fuel pump, or into the fuel tank, which communicates to the ECM the...

Service engine light on...car hesitates/stalls after stop

The EGR valve is a small component designed to allow the flow of exhaust gases into the intake manifold in controlled amounts. As such, it's a simple valve that closes and opens as needed. The EGR valve has one single...

What can cause the abs stablelink and traction control to turn off at the same time

The ABS and traction control lights and stab-link may share inputs from different sensors like the wheel speed sensors. You would need to test all of the systems to see if they all have the same failure as an input...

Thank you- I have a leak in the timing cover and my dealership saw that it is leaking from both [camshaft](/topics-camshaft/) areas, I have 122,000 miles on my 2014 subaru, would you think it be worth my getting them to replace the [head gasket](/topics-head-gasket/) too since they have the engine out? also -How safe is it when they put your engine out on a shelf to wait to get parts to put it back altogether?

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com