BMW 230i Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a BMW 230i Car Battery Replacement is $353 with $258 for parts and $95 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2018 BMW 230iL4-2.0L Turbo	Service typeCar Battery Replacement	Estimate$639.99	Shop/Dealer Price$781.24 - $1182.49
2020 BMW 230iL4-2.0L Turbo	Service typeCar Battery Replacement	Estimate$610.79	Shop/Dealer Price$749.76 - $1144.12
2019 BMW 230iL4-2.0L Turbo	Service typeCar Battery Replacement	Estimate$610.79	Shop/Dealer Price$749.76 - $1144.12
2017 BMW 230iL4-2.0L Turbo	Service typeCar Battery Replacement	Estimate$619.99	Shop/Dealer Price$761.24 - $1162.48
2021 BMW 230iL4-2.0L Turbo	Service typeCar Battery Replacement	Estimate$619.99	Shop/Dealer Price$761.27 - $1162.55

Show example BMW 230i Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(363)

Rating Summary

352

5

4

2

0

352

5

4

2

0

SEE REVIEWS NEAR ME

Jequan

7 years of experience

74 reviews

Jequan

7 years of experience

by Peter

BMW 135i L6-3.0L Turbo - Battery - Durham, North Carolina

Friendly and professional

Damian

11 years of experience

465 reviews

Damian

11 years of experience

by Christopher

BMW Z3 L6-2.8L - Battery - Washington, District of Columbia

Great service!

William

30 years of experience

49 reviews

Request William

William

30 years of experience

Request William

by Anita

BMW X3 L6-3.0L Turbo - Battery - Surprise, Arizona

We only want William to work on our BMW because he is fantastic!

Patrick

33 years of experience

1408 reviews

Request Patrick

Patrick

33 years of experience

Request Patrick

by Terry

BMW X5 V8-4.4L Turbo - Battery - Austin, Texas

Awesome job came early very efficient 

Excellent Rating

(363)

Rating Summary

352

5

4

2

0

352

5

4

2

0

SEE REVIEWS NEAR ME

Recent articles & questions

A Buyer’s Guide to the 2012 Mazda 6

The The Mazda 6 is a luxurious alternative to the everyday family sedan. It has decent fuel economy with an upscale look on both the inside and the outside. The vehicle also handles well on the highway and is comfortable...

P0192 OBD-II Trouble Code: Fuel Rail Pressure Sensor Circuit Low Input

P0192 trouble code definition Fuel rail pressure sensor circuit low input What the P0192 code means The power control module (PCM) has...

How to Replace a Fuel Injector

Fuel injectors are faulty if the smell of fuel is present in the vehicle, you have engine performance issues, or the check engine light comes on.

Car gets very low gas mileage

I would do a little quick research and find out what is typical real-world MPG for others who drive your make and model. That will provide you a realistic base-line expectation that will be more accurate that Mazda or EPA...

Turn signal not working

If the hazard warning lights use the same bulb (filament) as the turn signals, then yes it can't be the bulbs. I would test the turn signal flasher unit. Basically, you want to test for power to the flasher unit...

Where is purge valve for evap canister 07 honda civic si

The purge valve is mounted on the engine and you will see hose connections from the valve to the intake manifold as well as a wire harness connection. The purge valve should be tested to determine if it is actually...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com