Mitsubishi Van Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(1,979)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(1,979)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mitsubishi Van Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1990 Mitsubishi VanL4-2.4LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1987 Mitsubishi VanL4-2.4LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1988 Mitsubishi VanL4-2.4LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1989 Mitsubishi VanL4-2.4LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
Show example Mitsubishi Van Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mitsubishi mechanics

Real customer reviews from Mitsubishi owners like you.

Excellent Rating

(1,979)

Rating Summary
1,851
73
15
13
27
1,851
73
15
13
27

Derrick

11 years of experience
176 reviews
Derrick
11 years of experience
Mitsubishi Van L4-2.4L - Adjust Ignition Timing - Emeryville, California
What a cool service! Derrick kept in touch as he was on his way, was friendly and informative, and fixed the timing problem on my old, unusual car. The fee was reasonable, especially considering the mechanics come to your house.

Mike

22 years of experience
90 reviews
Mike
22 years of experience
Mitsubishi Galant L4-2.4L - Window Motor / Regulator Assembly Replacement (Driver Side Rear) - Richardson, Texas

Erick

10 years of experience
182 reviews
Erick
10 years of experience
Mitsubishi Eclipse V6-3.0L - 75 Point Safety Inspection - San Jose, California

Erick

10 years of experience
182 reviews
Erick
10 years of experience
Mitsubishi Montero V6-3.5L - Starter - Morgan Hill, California

Excellent Rating

(1,979)

Rating Summary
1,851
73
15
13
27
1,851
73
15
13
27
Number of Mitsubishi services completed
21769+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mitsubishi MECHANICS
700+
experts on our platform

Recent articles & questions

What Prevents the Fuel System From Leaking?
Leaking Leaking fuel is a hazardous and wasteful problem for a vehicle to have. Manufacturers know this, and to combat the problem they have implemented a number of simple ways to prevent fuel from leaking out of the fuel system:...
Symptoms of a Bad or Failing Exhaust Pressure Control Valve
Common signs include engine performance issues, excessive smoke or soot from the exhaust, and the Check Engine Light coming on.
How to Re-Start Your Second Generation Prius
Nobody Nobody wants their car to suddenly stop working. Unfortunately, Toyota recalled around 75,000 of their 2004 Prius cars because of some technical issues that were causing them to stall. This could be caused by several different failures in the...

can i put a murcury marauder transmission in a crown vic

The two transmissions are the same except with different gear ratios inside. Make sure the two transmissions have the same electrical connections before swapping them. The connectors will be different if the two transmissions are different years.

Need to replace the leak detection pump on my jeep.

Billing question sent to CS for the cost of replacing the leak detection pump on a 2005 jeep liberty.

How to seal an oil leak on a chevy 350?

This hole is specifically designed to be in that location and is for the oil pan dipstick. This is used to check the oil. I would suggest going to your local parts store and purchasing the correct dipstick for your...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com