Mercedes-Benz E400 Front Crankshaft Seal Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(4)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(4)

Front Crankshaft Seal Replacement Service

How much does a Front Crankshaft Seal Replacement cost?

On average, the cost for a Mercedes-Benz E400 Front Crankshaft Seal Replacement is $157 with $14 for parts and $142 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 Mercedes-Benz E400V6-3.5L HybridService typeFront Crankshaft Seal ReplacementEstimate$201.47Shop/Dealer Price$234.96 - $276.39
2014 Mercedes-Benz E400V6-3.5L HybridService typeFront Crankshaft Seal ReplacementEstimate$171.47Shop/Dealer Price$205.01 - $246.47
2013 Mercedes-Benz E400V6-3.5L HybridService typeFront Crankshaft Seal ReplacementEstimate$297.63Shop/Dealer Price$362.71 - $498.78
Show example Mercedes-Benz E400 Front Crankshaft Seal Replacement prices

What is the Front Crankshaft Seal all about?

A number of mechanisms must work together to make your vehicle move forward. One of the most important is the crankshaft, which converts rotary into linear motion; i.e., it transforms the force created by the engine's pistons moving up and down into a force that moves in a circular motion that causes a car’s wheel to turn. Enclosed in what’s called a crankcase—the largest cavity in the engine block, just below the cylinders—the crankshaft must be completely lubricated, essentially submerged in oil, to spin nearly friction-free and do its job properly.

Consequently, there are seals located at either end of the crankshaft that allow it to spin freely and keep engine oil from escaping the engine block, as well as prevent contaminants and other debris from entering and causing damage to the mechanism. Since there are two ends of the crankshaft, there are two types of seals: the front crankshaft seal and the rear crankshaft seal, also known as the front main and rear main seals.

Keep in mind:

  • Loss of oil will eventually cause serious internal engine damage.
  • Inspect the sealing surface of the crankshaft or the crankshaft pulley (depending on the engine design) for damage when replacing the crankshaft seal.
  • Oil degrades rubber components.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The crankshaft damper and timing belt is removed
  • The crankshaft seal is removed and a new one installed
  • The timing belt and cover along with crankshaft damper is reinstalled
  • The engine accessory belts are installed and the vehicle is lowered off of the jack stands

Our recommendation:

One of the most important parts of your car, crankshaft seals are typically made from a durable material, such as a synthetic rubber or silicone, designed to handle the extreme pressure and temperatures as well as the caustic chemicals in your engine oil. Because they are exposed to such abuse, main seals are subject to a lot of wear and tear. And whether you are talking a front or rear main seal, replacement is the only cure when one malfunctions.

The good news is that the seals are relatively inexpensive components. The bad news is that neither is easy to replace.

Front seal: The front seal is located behind the main pulley that drives all the belts, which is, of course, always spinning. The main pulley throws any leaking oil out in a big circle. It can get thrown up on the alternator, steering pump, belts, in short anything attached to the front of the engine and cause a real mess and eventually some serious damage. Consequently, it has to be removed along with many of the components attached to the front of the block to replace the front main seal.

Rear seal: The rear crankshaft seal is placed along with the transmission; therefore, the process of replacing it requires the removal of transmission, as well as the clutch and flywheel assembly. This is a very involved job.

What common symptoms indicate you may need to replace the Front Crankshaft Seal?

  • Oil leaking from the front crank pulley.
  • Oil dripping from the bottom of the clutch housing, where the block and transmission meet.
  • Clutch slip caused by oil spraying on the clutch.

How important is this service?

Letting either crankshaft seal continue to leak can be detrimental to your vehicle’s continued operation. Besides the maladies caused by driving around with little to no oil flowing in the engine, the faulty seal will be spread oil through the engine bay and undercarriage of your car as you drive, a mess that is difficult to clean up and can be a fire hazard. Replacing is better addressed sooner than later.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0

David

13 years of experience
393 reviews
David
13 years of experience
Mercedes-Benz E400 V6-3.0L Turbo - Pre-purchase Car Inspection - Kennesaw, Georgia
David called when he arrived and called shortly after he finished inspecting the vehicle. Unfortunately, due to the inefficiency of the sales representative at the dealership, David was not able to drive the vehicle as the final phase of the inspection.

Benji

22 years of experience
277 reviews
Benji
22 years of experience
Mercedes-Benz E400 V6-3.0L Turbo - Pre-purchase Car Inspection - Scottsdale, Arizona
Mr. Tolbert was on time. I was not present for his inspection, but the dealership told me that he was very professional.

Josh

16 years of experience
78 reviews
Josh
16 years of experience
Mercedes-Benz E400 V6-3.0L Turbo - Pre-purchase Car Inspection - Naples, Florida
Awesome inspector , very detail oriented and caring. Thanks

Dawit

15 years of experience
29 reviews
Dawit
15 years of experience
Mercedes-Benz E400 V6-3.0L Turbo - Oil Change - Washington, District of Columbia
Dawits was punctual and expedient in the service of my vehicle. I will definitely request him again.

Excellent Rating

(4)

Rating Summary
4
0
0
0
0
4
0
0
0
0
Number of Mercedes-Benz E400 services completed
44+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Tell if Your Car is Front or Rear-Wheel Drive
Every Every car has a drivetrain of some sort. The drivetrain is a system of transferring your car engine’s horsepower to the drive wheels that propels your car. The drivetrain consists of: Axle shafts Differential Propeller shaft Transfer case Transmission...
How to Keep Your Car Running Well When It’s Hot Outside
Your Your car is affected considerably by the environment around it, including: Cold, freezing temperatures Dry, arid climates Hot temperatures and direct sunlight Precipitation in the form of rain or snow If your car is exposed to moisture all the...
P2455 OBD-II Trouble Code: Diesel Particulate Filter Differential Pressure Sensor Short to Voltage
P2455 P2455 code definition Diesel Particulate Filter Differential Pressure Sensor Short to Voltage What the P2455 code means P2455 is an OBD-II generic code that the engine control module (ECM) has detected the diesel particulate filter differential pressure sensor (DPFPS)...

What does the charging system Warning Light mean in a 2012 Ford Explorer?

The charging system Warning Light is located on the instrument panel. This light illuminates when your vehicle’s battery is not charging properly. It’s important to have this issue resolved quickly, or else your battery may not be able to charge,...

I put a engine out of a 2007 malibu in the 2005 cobolt. Why will the engine not start

Hi there. Check all of the sensors to the engine and make sure that all of them are connected. Check the computer and see if there is an wires disconnected to it. A loose wire on any electrical system will...

Water pump

Hello, thank you for writing in. You are correct in assuming the water pump may be to blame. You may also want to make sure the fans are turning on, and that your radiator and overflow tank both have the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com