Mercedes-Benz 420SEL Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(19)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(19)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Mercedes-Benz 420SEL Car Battery Replacement is $387 with $247 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1990 Mercedes-Benz 420SELV8-4.2LService typeCar Battery ReplacementEstimate$680.38Shop/Dealer Price$818.03 - $1216.79
1991 Mercedes-Benz 420SELV8-4.2LService typeCar Battery ReplacementEstimate$671.37Shop/Dealer Price$805.92 - $1202.37
Show example Mercedes-Benz 420SEL Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(19)

Rating Summary
18
0
0
1
0
18
0
0
1
0

Dwaine

46 years of experience
39 reviews
Dwaine
46 years of experience
Mercedes-Benz 420SEL V8-4.2L - Oil Cooler Hose (Automatic Transmission) - Brandon, Florida
Great experience, very polite and knowledgeable mechanic.

David

33 years of experience
107 reviews
David
33 years of experience
Mercedes-Benz 420SEL V8-4.2L - Pre-purchase Car Inspection - Phoenix, Arizona
I felt comfortable with David working on my vehicle. I felt he was honest with me and will recommend his services, as well as, yourmechanics' services to friends and family.

Manuel

13 years of experience
140 reviews
Manuel
13 years of experience
Mercedes-Benz 420SEL V8-4.2L - Oil Pressure Sensor Replacement - Naples, Florida
First class service. Knowledgeable and considerate.

Erick

11 years of experience
182 reviews
Erick
11 years of experience
Mercedes-Benz 420SEL V8-4.2L - Oil Change - Palo Alto, California

Excellent Rating

(19)

Rating Summary
18
0
0
1
0
18
0
0
1
0
Number of Mercedes-Benz 420SEL services completed
209+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

P0558 OBD-II Trouble Code: Brake Booster Pressure Sensor Circuit High
P0558 means there is a voltage problem with the brake booster pressure sensor, likely due to vacuum leaks or a faulty sensor.
A Buyer’s Guide to the 2012 Mercedes-Benz SLS AMG
Powerful, Powerful, aggressive and streamlined, the 2012 Mercedes-Benz SLS AMG is a precision-crafted supercar. It was offered originally as a coupe, but this year saw the addition of a roadster body style. Key Features From the 7-speed dual clutch to...
How Long Does a Brake Caliper Last?
The The braking system on your car has a variety of different parts that have to work together in order to bring the car to a stop. Most car owners take their braking system for granted until there is a...

P0170 and P0173, I have changed the MAF and Both sensors. Now my car does not start.

P0170 and 173 indicate that your fuel mixture is off. The ECU tries to compensate, but the error is so large that it cant make the correction. It can be caused by a Mass Air Flow sensor, but there could...

Car feels like it is in neutral

This is often a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...

Hi, I have 2007 mercedes banz and check engine light in my dashboard with a code P0017.

With the code P0017, the crankshaft position sensor is not picking up the engines speed properly. Check the following areas for any issues to fix your P0017 code issue. Check the following: The timing chain could be stretched The timing...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com