Dodge D200 Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(307)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(307)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Dodge D200 Water Pump Replacement is $286 with $143 for parts and $142 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1976 Dodge D200V8-5.2LService typeWater Pump ReplacementEstimate$562.01Shop/Dealer Price$674.39 - $977.78
1979 Dodge D200V8-5.9LService typeWater Pump ReplacementEstimate$428.73Shop/Dealer Price$515.31 - $741.27
1976 Dodge D200V8-5.9LService typeWater Pump ReplacementEstimate$428.73Shop/Dealer Price$515.31 - $741.26
1975 Dodge D200L6-3.7LService typeWater Pump ReplacementEstimate$478.25Shop/Dealer Price$577.18 - $840.24
1977 Dodge D200L6-3.7LService typeWater Pump ReplacementEstimate$478.25Shop/Dealer Price$577.24 - $840.34
1975 Dodge D200V8-5.9LService typeWater Pump ReplacementEstimate$428.73Shop/Dealer Price$515.31 - $741.26
1978 Dodge D200L6-3.7LService typeWater Pump ReplacementEstimate$485.75Shop/Dealer Price$584.51 - $847.44
1980 Dodge D200V8-5.9LService typeWater Pump ReplacementEstimate$436.23Shop/Dealer Price$523.17 - $749.38
Show example Dodge D200 Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Dodge mechanics

Real customer reviews from Dodge owners like you.

Excellent Rating

(307)

Rating Summary
294
10
0
1
2
294
10
0
1
2

Russell

24 years of experience
356 reviews
Russell
24 years of experience
Dodge D200 V8-5.2L - Car is not starting - Portland, Oregon
Really helpful!

Russell

24 years of experience
356 reviews
Russell
24 years of experience
Dodge D200 V8-5.2L - Fuel Pump Replacement - Portland, Oregon

Walter

46 years of experience
341 reviews
Walter
46 years of experience
Dodge Ram 2500 L6-5.9L Turbo Diesel - Water Pump - Tulsa, Oklahoma
Mr Walter was both efficient and thorough. Thank you.

Pardeep

21 years of experience
1068 reviews
Pardeep
21 years of experience
Dodge Magnum V8-5.7L - Water Pump - Fremont, California
Very good.

Excellent Rating

(307)

Rating Summary
294
10
0
1
2
294
10
0
1
2
Number of Dodge Water Pump Replacement services completed
3377+
services done by our mechanics
TOTAL NUMBER OF EXPERT Dodge MECHANICS
1400+
experts on our platform

Recent articles & questions

P0733 OBD-II Trouble Code: Gear 3 Incorrect Ratio
P0733 Code Definition Gear 3 incorrect ratio is the technical definition of the P0733 trouble code What the P0733 code means The...
Veteran and Military Driver Laws and Benefits in Wisconsin
The The state of Wisconsin understands how difficult it can be for military members to keep up with license renewals and other requirements that apply to regular drivers, and the state has taken steps to make things easier. They’ve also...
How to Diagnose Your Brake Issues
Car brake problems can be caused by different things. You can fix your brakes after doing a visual inspection and some brake tests in a safe space.

How do I use the universal garage door opener?

If your car is equipped with the Car2U® universal garage door opener (optional equipment), it provides you with a handy way to operate not only your home’s garage door, but other automated systems, like remote lighting systems, gate systems and...

How do I customize the Memory Remote Recall?

The Memory Remote Recall feature remembers the seat and side mirror settings that were last used by a driver, and returns to those settings when the remote keyless entry (RKE) transmitter is used to unlock the vehicle. To turn the...

It making a funny noise when i crank it up

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com