Oldsmobile Alero Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(3)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(3)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Oldsmobile Alero Water Pump Replacement is $311 with $115 for parts and $196 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2000 Oldsmobile AleroV6-3.4LService typeWater Pump ReplacementEstimate$446.02Shop/Dealer Price$508.32 - $683.86
1999 Oldsmobile AleroV6-3.4LService typeWater Pump ReplacementEstimate$433.41Shop/Dealer Price$493.23 - $666.92
2004 Oldsmobile AleroV6-3.4LService typeWater Pump ReplacementEstimate$433.41Shop/Dealer Price$493.26 - $666.98
2001 Oldsmobile AleroV6-3.4LService typeWater Pump ReplacementEstimate$433.41Shop/Dealer Price$493.26 - $666.98
2003 Oldsmobile AleroV6-3.4LService typeWater Pump ReplacementEstimate$433.41Shop/Dealer Price$495.32 - $670.59
2002 Oldsmobile AleroV6-3.4LService typeWater Pump ReplacementEstimate$433.41Shop/Dealer Price$493.46 - $667.32
Show example Oldsmobile Alero Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Oldsmobile mechanics

Real customer reviews from Oldsmobile owners like you.

Excellent Rating

(3)

Rating Summary
3
0
0
0
0
3
0
0
0
0

Excellent Rating

(3)

Rating Summary
3
0
0
0
0
3
0
0
0
0
Number of Oldsmobile Alero Water Pump Replacement services completed
33+
services done by our mechanics
TOTAL NUMBER OF EXPERT Oldsmobile MECHANICS
300+
experts on our platform

Recent articles & questions

5 Essential Things to Know When Considering Buying a Classic Car
Classic Classic cars, which are those that are at least 10 years old and have historical interest based on production numbers or workmanship, certainly play a siren song for many who want to relive memories from their youth. However, before...
How to Buy a Personalized License Plate in Oklahoma
A A personalized license plate is a great way to add some fun and some personality to your vehicle. With a personalized license plate, you can show public support for your favorite college sports team, advertise your family’s business, give...
How Long Does a Power Window Switch Last?
Power Power windows are definitely convenient, particularly with the auto up and down functionality that’s now present in many newer cars. It sure beats having to manually roll the window up or down when you need to get some fresh...

2007 saturn vue green line battery replacement

First, you will want to locate the battery on your vehicle. Then, disconnect the negative cable on the battery first. Next, disconnect the positive cable. Finally, remove any hold down hardware and remove the battery. In order to install the...

I have a Ford Focus the car is jerking and engine light turns on but turns off when I shut the car off

A couple of things may cause this to happen such as a faulty cam position sensor a transmission problem or in some cases a dirty or faulty idle air control valve. The camshaft position sensor is a magnetic sensor that...

My car was driving fine and then I went to turn into a parking lot and it stalled. I started it back up then it stalled again. In

An engine that starts and stalls can be caused by many things and you will need to have the computer and fuel pressure tested to isolate the cause by a mechanic like one from YourMechanic.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com