Chevrolet R2500 Suburban Front Crankshaft Seal Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(40)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(40)

Front Crankshaft Seal Replacement Service

How much does a Front Crankshaft Seal Replacement cost?

On average, the cost for a Chevrolet R2500 Suburban Front Crankshaft Seal Replacement is $255 with $17 for parts and $238 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1991 Chevrolet R2500 SuburbanV8-7.4LService typeFront Crankshaft Seal ReplacementEstimate$302.72Shop/Dealer Price$318.65 - $352.65
1991 Chevrolet R2500 SuburbanV8-5.7LService typeFront Crankshaft Seal ReplacementEstimate$291.38Shop/Dealer Price$305.30 - $340.04
1991 Chevrolet R2500 SuburbanV8-6.2L DieselService typeFront Crankshaft Seal ReplacementEstimate$287.40Shop/Dealer Price$300.37 - $332.15
1990 Chevrolet R2500 SuburbanV8-6.2L DieselService typeFront Crankshaft Seal ReplacementEstimate$287.40Shop/Dealer Price$300.37 - $332.15
1990 Chevrolet R2500 SuburbanV8-5.7LService typeFront Crankshaft Seal ReplacementEstimate$1190.78Shop/Dealer Price$1432.10 - $2143.29
1990 Chevrolet R2500 SuburbanV8-7.4LService typeFront Crankshaft Seal ReplacementEstimate$287.40Shop/Dealer Price$300.61 - $332.57
Show example Chevrolet R2500 Suburban Front Crankshaft Seal Replacement prices

What is the Front Crankshaft Seal all about?

A number of mechanisms must work together to make your vehicle move forward. One of the most important is the crankshaft, which converts rotary into linear motion; i.e., it transforms the force created by the engine's pistons moving up and down into a force that moves in a circular motion that causes a car’s wheel to turn. Enclosed in what’s called a crankcase—the largest cavity in the engine block, just below the cylinders—the crankshaft must be completely lubricated, essentially submerged in oil, to spin nearly friction-free and do its job properly.

Consequently, there are seals located at either end of the crankshaft that allow it to spin freely and keep engine oil from escaping the engine block, as well as prevent contaminants and other debris from entering and causing damage to the mechanism. Since there are two ends of the crankshaft, there are two types of seals: the front crankshaft seal and the rear crankshaft seal, also known as the front main and rear main seals.

Keep in mind:

  • Loss of oil will eventually cause serious internal engine damage.
  • Inspect the sealing surface of the crankshaft or the crankshaft pulley (depending on the engine design) for damage when replacing the crankshaft seal.
  • Oil degrades rubber components.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The crankshaft damper and timing belt is removed
  • The crankshaft seal is removed and a new one installed
  • The timing belt and cover along with crankshaft damper is reinstalled
  • The engine accessory belts are installed and the vehicle is lowered off of the jack stands

Our recommendation:

One of the most important parts of your car, crankshaft seals are typically made from a durable material, such as a synthetic rubber or silicone, designed to handle the extreme pressure and temperatures as well as the caustic chemicals in your engine oil. Because they are exposed to such abuse, main seals are subject to a lot of wear and tear. And whether you are talking a front or rear main seal, replacement is the only cure when one malfunctions.

The good news is that the seals are relatively inexpensive components. The bad news is that neither is easy to replace.

Front seal: The front seal is located behind the main pulley that drives all the belts, which is, of course, always spinning. The main pulley throws any leaking oil out in a big circle. It can get thrown up on the alternator, steering pump, belts, in short anything attached to the front of the engine and cause a real mess and eventually some serious damage. Consequently, it has to be removed along with many of the components attached to the front of the block to replace the front main seal.

Rear seal: The rear crankshaft seal is placed along with the transmission; therefore, the process of replacing it requires the removal of transmission, as well as the clutch and flywheel assembly. This is a very involved job.

What common symptoms indicate you may need to replace the Front Crankshaft Seal?

  • Oil leaking from the front crank pulley.
  • Oil dripping from the bottom of the clutch housing, where the block and transmission meet.
  • Clutch slip caused by oil spraying on the clutch.

How important is this service?

Letting either crankshaft seal continue to leak can be detrimental to your vehicle’s continued operation. Besides the maladies caused by driving around with little to no oil flowing in the engine, the faulty seal will be spread oil through the engine bay and undercarriage of your car as you drive, a mess that is difficult to clean up and can be a fire hazard. Replacing is better addressed sooner than later.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(40)

Rating Summary
35
2
1
0
2
35
2
1
0
2

James

32 years of experience
705 reviews
James
32 years of experience
Chevrolet R2500 Suburban V8-7.4L - Universal Joint (U-joint) - Lakewood, California
James was awesome

David

11 years of experience
193 reviews
David
11 years of experience
Chevrolet Cruze L4-1.4L Turbo - Front Crankshaft Seal - Philadelphia, Pennsylvania
Fast worker but an hour late for appointment... overall good job

James

31 years of experience
1039 reviews
James
31 years of experience
Chevrolet Spark L4-1.2L - Front Crankshaft Seal - Longwood, Florida
James is the best mechanic around he fixed my vehicle so fast it was truly amazing. He also helped me to understand the problems that occurred and showed me before and after photo of the work being done.

Kenneth

28 years of experience
12 reviews
Kenneth
28 years of experience
Chevrolet Monte Carlo V6-3.9L - Front Crankshaft Seal - Grand Prairie, Texas
Great job and very attentive to detail. Highly recommended!

Excellent Rating

(40)

Rating Summary
35
2
1
0
2
35
2
1
0
2
Number of Chevrolet Front Crankshaft Seal Replacement services completed
440+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1700+
experts on our platform

Recent articles & questions

How to Get GMC Dealership Certified
GMC car dealerships offer automotive technician jobs to mechanics who are certified through one of the many programs they have available.
How to Replace a Manifold Absolute Pressure (MAP) Sensor
Signs of a faulty manifold absolute pressure sensor include excessive fuel use and lack of power with your car. You may also fail an emissions test.
A Buyer’s Guide to the 2012 Lexus HS 250h
Hybrids Hybrids have come a long way in the last few years, and the 2012 Lexus HS 250h is a prime example of just how much they’ve evolved. This sedan is quiet, composed and chock-full of high tech equipment. Key...

Plastic piece under my car is dragging on the road

This is the same cover that needs to be removed to service the oil and filter. If the cover is not being removed and reinstalled completely by repairer, then it becomes warped over time. Unfortunately Toyota has not recalled this...

Exhaust gases in coolant

How do I flush stop leak out of engine/radiator?

If somebody has put 'stop leak' inside the radiator, it will flow through the entire coolant system and has possibly created an obstruction in the heater core or other cooling system component. If you flush the system, it's possible the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com