Q: where is the crank position sensor located we can't locate it

For some reason Ford used three different evaporator case designs in the trucks this year. The filter will be in one of these three locations. Look behind the glove box and there is a cover on case and filter is...

Hello there, many common faults will cause issues with the clutch on your 1998 Chevrolet S10. If the clutch line is continually disconnecting there are a few common faults. The most likely is a failing slave cylinder, air in the...

Hello, thank you for writing in. To start, the generator is the alternator. It generates the power supply for the vehicle based off the vehicle's engine performance. There are several ways to approach the repair. You may remove the starter...

Hello, thank you for writing in. When there are issue with the vehicle's gas recirculation system, the engine may pull in excess exhaust fumes. This will cause the engine to run rich and make the catalytic converter unable to compensate...

Check to see if the starter motor pinion gear is jammed in the ring gear on the flex plate. On the off chance that somehow the transmission is the issue, you can also try disconnecting the torque converter from the...

The two codes, P0736 (https://www.yourmechanic.com/article/p0736-obd-ii-trouble-code-reverse-incorrect-gear-ratio-by-valerie-johnston) and P0730 (https://www.yourmechanic.com/article/p0730-obd-ii-trouble-code-incorrect-gear-ratio-by-ian-swan) overlap to some extent insofar as possible faults. If the transmission fluid got really low, the transmission might have overheated with several consequences: burnt fluid; mechanical damage, case/part distortion, damage to hydraulic...

Hi Andrew. Thanks for the follow-up question. I've forwarded your question to our service and sales department so they can work up an estimate for you to have the actuator and accumulator on your Toyota Prius replaced. They'll contact you...

You should have the computer checked for failure codes first and see if the camshaft or crank sensors are bad. Then have fuel pressure checked to see if pressure is too low.

This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, making turns (which makes use of the power steering pressure switch) turning on...