Q: When putting foot on accelerator, brake, or shifter, car dies
My car starts properly and also sounds good, but the problem is when I put my foot on the accelerator, the brake, or engage the shifter, the car starts to sputter and then dies. When I called the dealership, they said it is probably in Lag mode and the ecm probably need to be reprogrammed. Before allowing them to go forward with this, can you tell me if this is what you would recommend too?
Recommended Services
| Engine is sputtering Inspection | $94.99 - $114.99 | Get a Quote |
A few different faults can cause the vehicle to go into a limp mode. The ECU puts the car into this mode to prevent damage and will be associated with a Check Engine Light. The most likely causes are a misfire condition, catalytic converter, transmission malfunction or low fuel pressure. A qualified technician, such as one from YourMechanic, will be able to diagnose the sputtering problem and perform any repairs required.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Can I Let the Washer Fluid Reservoir Run Dry?
It is best to keep any fluid system in your car from running dry. The washer system often sits unused, so it can be easily forgotten. When the fierce winter weather is upon us, it is easy to think of...
How do I use the compass?
Some models of the vehicle come equipped with a compass that is visible in front of the driver. The compass, in order to remain accurate, must be set to work in the zone that the vehicle is in. This is...
What does the AdvanceTrac® Light mean on the dash?
Your car is equipped with an advanced traction and stability control system called AdvanceTrac®. The system is always on unless you manually turn it off. The AdvanceTrac® Light should come on in the dash when you first crank the engine...
Mass air flow issues
Try taking the mass air flow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) out and cleaning it as these can often times trigger a code simply as a result of just being dirty. By far the most common MAF failure is caused by accumulation of...
Car continues to run after taking the key out of ignition
If the rest of the vehicle is staying powered up as well (radio, lights, etc.), then there may be a problem with the ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement). Otherwise, there may be a shorted circuit allowing the fuel pump and ignition system...
car shakes only between 35-40 mph
Hello. Most of the time when you get a vibration at a higher speed such as this it is caused by a balance issue. The tire balance can be off or one of the tires may be slightly out of...
Glow Plug warning Light is On
The little orange light that looks like a spring is the Glow Plug Warning Light. But when it comes on, it doesn't necessarily mean you have a problem with your glow plugs. Like the check engine light, it means that...
Does the rear wheel bearing replacement needs pressing or not? 2004 Acura RL
Hello - if you replace the wheel bearing/hub assembly (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-wheel-bearing-gone), no, it does not require pressing. This is the recommended replacement approach. Pressing the bearing off/onto the hub requires specialized equipment, with high risk for damage. I would recommend a...
2000 Ford Taurus won't shift out of park and brake lights don't work
Check fuse number 217 for power in the under dash fuse panel. If you have no power to fuse then the fuse panel needs replaced. If you have power then check for broken wires at the brake switch connector.
Related articles
Should the Brake Fluid Be Flushed Every Time the Brakes Are Replaced?
While While it’s possible to get away with simply topping off your brake fluid with a brake replacement, Replacing the brakes is the ideal time to perform a brake fluid flush. For starters, you or your mechanic is already in...
Is There a Difference Between a Parking Brake and an Emergency Brake?
An An auxiliary brake is a brake system that's separate from your regular foot-pedal brake system. Auxiliary brakes are more commonly called a parking brake, an emergency brake, or a handbrake, and are connected to calipers that grip onto the...
How Car Acceleration Works
Going from 0 to 60 mainly involves the throttle, engine, differential, and tires of a car. How fast it takes depends on the features of these parts.
Browse other content
Maintenance
Estimates