Q: Car shakes when I press accelerator

asked by on November 26, 2016

My car has been in need of tune up for about 2 weeks now was getting ready to do it but as of the past week every time I step on the accelerator my car shakes and it doesn't always happen butt sometimes it'll run fine and others it'll Shake really badly and as soon as I take my foot off the gas it goes away but when I step back on it comes back

My car has 102675 miles.
My car has an automatic transmission.

Throttle Position Sensor Replacement $144.21 - $717.44 Get a Quote

This may be a sign of a failing throttle position sensor. The throttle position sensor (TPS) is a sensor used to monitor the throttle position of the throttle plate inside the throttle body in relation to your foot position on the gas pedal. Based upon the inputs from the sensor reading your foot’s position on the pedal, the ECU then makes the direction to supply more or less fuel to the motor. When this sensor is not working properly, this can cause intermittent responses when pressing the gas pedal. I would suggest having a professional from Your Mechanic come to you home to diagnose your throttle control system.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Can't pass smog check due to misfire
If your engine is misfiring it will not pass a smog check. The engine needs to be in good running condition in order to pass. I suggest having an expert mechanic, such as one from YourMechanic, inspect why your engine...
Alternator problem, the wipper stops as soon as you take it to the highest,cracking sound in the morning that stop after cluching
Hello. From what you describe it would appear that the vehicle is experiencing more than one issue. The first thing I would address is the alternator, as a faulty alternator can leave the vehicle stranded if the battery dies. I...
I am trying to figure out what type of differential a car usally has?
Think about the differentials (https://www.yourmechanic.com/advice/tag/differentials) in a different way. The non-driven wheels already spin independently of each other, and therefore needing a differential is not necessary on those wheels. On driven wheels, the drivetrain must be able to power both...
2008 Kia Sportage oil pan replacement
Hello. Thank you for writing in. Replacing the oil pan can be tricky and time consuming. Often the engine or the transmission need to be moved or adjusted in order to access and work on the oil pan. Sometimes the...
Bypass a.c. compressor with a short serpentine belt, can this be done if not what about a bypass pulley?
The compressor cannot be bypassed without the use of a compressor bypass pulley. It would cost more for a bypass for the compressor than it would be to just replace the compressor pulley. Install a new pulley or pulley bearing...
I replaced my engine of w221 s350 with this engine 272 946 31142350 they told me its for glk 350 2011 model how can I tell if thi
Hi there. Your best bet is to contact Mercedes-Benz dealership and speak with their service or parts department to get the information you're seeking. We offer general automotive tips and maintenance / service recommendations for our site visitors. Thanks.
Conversion kits and price on 2011 jeep grand cherokee. From air to coil suspension
Unfortunately, we don't provide mechanical services on aftermarket upgrades or offer technical advise on those installations. I would recommend contacting a Jeep suspension specialist shop to online owner forum to receive the info you're requesting.
Loud clunking noise from front driver side when braking hard or hitting a pot hole.
You may have a worn out strut on the drivers side or the strut upper bushing is worn out. I suggest having the struts checked. Also the front brake pads may be moving inside the brake caliper. Have the complete...
1986 lincoln town car stalls while driving, drives good for a bit, then jerks, soon after motor cut off. has to sit awhile4restart
You should have the fuel pressure checked when the vehicle stalls to see if you are losing fuel pressure since you notice the pump is noisey when running. The pump is most likely losing pressure when it gets hot and...

Related articles

How to Replace an AC Evaporator Sensor
The air conditioning pressure evaporator sensor monitors and adapts to the evaporator's temperature, preventing damage and keeping the AC working.
How to Replace an Anti-Lock Brake Fluid Level Sensor on Most Modern Cars
The anti-lock brake (ABS) system has a fluid level sensor that fails when the warning light comes on or if there is low fluid in the reservoir.
P0337 OBD-II Trouble Code: Crankshaft Position Sensor A Circuit Low Input
P0337 means that the crankshaft is suffering because of low voltage. This could be due to sensor not being aligned properly or electrical problems.