Q: Transmission is stuck in high gear. Even when I stop it takes off in high gear.

asked by on February 22, 2017

I can put it in reverse does good put it in drive and u got to hold gas to floor to get it moving but when it gets moving its fine .. It stays in drive even if I manually put it in low 1 it still takes off in drive. Its not slipping or nothing just want gear down when u stop

My car has 200000 miles.
My car has an automatic transmission.

Electric Problems Inspection $94.99 - $114.99 Get a Quote

The transmission is stuck in limp mode. Check to see if the harness to the transmission is damaged or loose. When the transmission looses power (electrical power), the transmission defaults to the third gear selection as that is the gear that does not require any shifting with electronics. If the harness is good and the harness is supplying power to the transmission, then the harness inside the transmission maybe damaged. I recommend seeking out a professional, such as one from Your Mechanic, to help you diagnose your transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Oil pressure low in truck
The knocking noise is the piston rod bearings or the crankshaft main bearings. A failure of either of these will create a drop in oil pressure along with the knock. This internal engine failure will only get worse and will...
Is the pcv supposed to fit loose on the valve cover? And how do you remove the pcv itself?
The PCV on this engine has a lock tab and unscrews from the valve cover. The tab may break when you try and remove it so make sure you have the correct one before you try and remove the old...
My temp gauge reads low, but I replaced the thermostat.
In order to properly test the cooling system you'll need to test the temperature at the temperature sending unit with a laser temperature tester or something equivalent. You'll also need a scanner to look at the reading to the ECM...
Car vibrates/shakes when sitting still in idle (in gear or in neutral).
This sounds as if you have a low idle condition. I can say your car isn't likely to suffer a catastrophic failure because of this. With a condition such as this, it is normal for it to run rougher (https://www.yourmechanic.com/services/car-idle-is-rough-inspection)...
Service stabilizer and traction control warning is on.
Your car is equipped with wheel speed sensors (https://www.yourmechanic.com/services/wheel-speed-sensor-replacement) at each of the four wheels which monitor wheel speed while relaying this information constantly to the ABS and traction control system which are controlled by the car's ECU. When the...
My car's windshield wiper only works sometimes
Hello. Most of the time on this vehicle the reason why the wipers stop working is because of the park sensor for the wipers. This detects the position of the wipers and that is used for operation. If the sensor...
My car lost power with the engine revving. Then the wheels locked down and died and won't start back up
Hi there. It sounds like you may have experienced an internal failure of the transmission, rear differential, or the brake system. Check for marks on the pavement for the tires and determine if it was all four or only two...
Cranks but doesn't start and also I don't see the rpm move when I try to start, what should I do? - 2002 Nissan Altima
Hello - I suspect your crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor)has failed. This sensor provides the ignition system with timing information - when to fire each spark plug. This sensor is also the trigger for the tachometer, since it is counting engine...
Throttle Body, PCV tube, and valve cover seal needs replaced.
Billing question sent to CS for replacement cost of the PCV tube and valve cover seal.

Related articles

A Buyer’s Guide to the 2012 Hyundai Genesis
The The 2012 Hyundai Genesis is a midsize luxury sedan that is both powerful and well equipped with lots of standard features. It has an elegant look with the choice between V6 or two V8 engines. This four door sedan...
The Best Used Cars to Buy If You Just Got Your License
If If you are a new driver, congratulations on getting your license. Now, you need to think about what type of vehicle to buy. Ideally, you’ll choose a used car that isn’t overly expensive, and is reliable and safe while...
How Long Does a Shift Interlock Solenoid Last?
Modern Modern transmissions are much more advanced than they were only a few decades ago, particularly automatic transmission. There are many new features and designs on the market, ranging from ‘slick’ shifting transmissions to manual shift paddles on the steering...