Q: The trunk lid wont stay up by its self have to hold it up with my hand. Its a Oldsmobile alero 2004

asked by on August 10, 2017

The trunk lid wont stay up by its self have to hold it up with my hand dont know why it dont stay up. Its a Oldsmobile alero 2004

My car has 230000 miles.
My car has an automatic transmission.

You will need to replace both of the trunk lid support shocks. They will lose their gas charge over time and will no longer support the lid weight.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I start the car if I have keyless ignition and the transmitter battery is low?
The keyless ignition system allows you to turn on your vehicle without a key, simply by using the remote keyless entry (RKE) transmitter. If the transmitter battery is dying, however, the keyless ignition system will not operate normally. When this...
Oil leaking under car
Hello, if the oil leak is big enough that you see it dripping on the ground, it should be inspected sooner than later to avoid damage. There are three possible sources of an oil leak, the engine, the transmission, and...
Brake piston seized after brake pad change
Was this the rear brakes? Many times the rear calipers have to be turned in with a special press that turns the piston and presses the piston in at the same time. This is because the parking brake is built...
The car slides when driven on bumpy roads
Hello. If the vehicle has aftermarket wheels on it then they may have the wrong offset which will cause this. If the wheels are original then the rear suspension needs to be checked for worn parts. If the suspension is...
Shifting has become much harder, especially 1st gear and reverse, and sometimes I can't shift into any gear.
Hi. Usually when a manual transmission is hard to shift, it means that the slave cylinder is malfunctioning and needs to be replaced. The purpose of the slave cylinder is to make shifting of the transmission smooth and effortless for...
How do I find top dead center using the teeth on the harmonic balancer?
Hi there. The following steps are to check for top dead center on your engine. Remove the left valve cover on the engine rotate the crankshaft until the key way is facing up Check the camshaft on the left that...
High idle after replacing fuel pump tps and air idle control valve
The first thing to do is to verify there are no vacuum leaks in the engine and verify the installation of the parts. Once this is done then disconnect the battery and then let sit for two minutes and reconnect...
Service advance trac light is on, anything I can do before I take it somewhere? No mechanic experience
Hello, thank you for writing in. The first step is to scan the vehicle for diagnostic codes. You can then use those to help you figure out where to turn your attention. Chances are there has been damage to the...
How do i remove/replace cupholder in rear 60/40 bench seat of 2012 Nissan Murano SL? I have OEM replacement part.
Hi James. Thanks for contacting us today. Any time you replace OEM components, it is best to refer to the OEM service and repair manual. If you don't have one, I would recommend contacting a Nissan dealership and asking their...

Related articles

Symptoms of a Bad or Failing Trunk Latch Release Cable
Common signs include the trunk not unlatching when the handle is pulled and the trunk latch handle feeling loose.
Symptoms of Bad or Failing Trunk Lift Support Shocks
Common signs include the trunk lid being hard to open, not staying open, or not opening at all.
How Long Does a Trunk Lock Actuator Last?
The The trunk of a car is designed to transport anything that the driver has that will not fit in the cabin of the vehicle. There are a variety of different mechanisms that allow the trunk to function as intended....