Q: Rubbing sound when going over bumps even after replacing the struts.

asked by on November 17, 2016

Had new struts put on a year ago at Midas and every time I would hit a small bump, even in a parking lot, there was a rubbing/squeaky noise coming from front end. They told me to give it a couple months to "seat" properly. Well, problem continued and today they replaced the struts with new ones (free of charge) and the noise is even more noticeable. They said it could be ball joints or any number of other things but they don't know what it is. I am reluctant to take it back to them. Any thoughts? Thank you.

My car has 111000 miles.
My car has an automatic transmission.

Hi there:

When struts are replaced, they typically take a while to break in; which during this time period, other mechanical problems such as worn out CV joints, ball joints, or stabilizer bar bushings can cause the issues you’re describing. I agree, it’s best to not take your vehicle to this other shop; however, it’s probably a good idea to have a professional technician, such as one from YourMechanic, come to you and complete a car is making a noise inspection. During this service, the mechanic will test drive and inspect your vehicle to determine what’s causing the noise you’re hearing; so that the right repairs can be made.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

AC blowing out warm air again
If this happened right after the work was done then you either have a leak in the system that allowed the refrigerant to come out or there is an electrical issue. It is possible that this was overlooked if the...
Trunk not closing
The latch is most likely to blame. The latch is on the trunk lid, the striker is bolted to the bottom. Check the lever in the latch is not partially closed. Have someone hold the trunk release lever, take a...
my rpms remain around 2500 rather than dropping down to the normal 500-1000 idle speed
An intake manifold vacuum leak is likely the issue with your VW. Have a close look at all vacuum hoses that connect to the intake manifold. The large hose that connects to the brake booster is a suspect. Listen closely...
2004 Saturn Vue...Right Front brake hanging up, replaced caliper and master cylinder and still hanging up.
High brake effort can be caused by a restriction in the system. What can happen with the brake system is the brake hoses attached to caliper degrade internally causing a restriction. The hose will collapse under pressure.
TCS light stays on for days, and then comes off for like a week, then comes back on for days again.
Hello, thanks for writing in. There are a lot of things that can cause this. Most of the time if the vehicle is running fine it comes on from low brake fluid or a failing wheel speed sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-wheel-speed-sensor). If...
Wheel hop/ wobble
Hello. There are several components that may be causing these symptoms. The easiest to check is the condition of the tires. If they are cracked, warped, low, misaligned then you will possibly have these symptoms. More likely it is related...
Can build pressure in front brakes
In order to properly bleed the ABS brakes on this vehicle you will need to have a scanner that can put the ABS into bleed mode. This will open the valves in the ABS brake modulator so you can bleed...
white smoke from 95 toyota camry.
Hi there. Usually white smoke coming from the exhaust pipe is caused by a mixture of engine oil and coolant. In most cases, this is caused by damage to the engine, like a blown head gasket or cracked engine block....
intermittent wipers not working and windshield washer not working on 2009 ford expedition
This sort of fault is typically diagnosed using a volt/ohm meter with the factory wiring schematic in hand. The type of circuit interruption involved can vary a lot from something as mundane as a bad ground connection to the more...

Related articles

What Components of the Suspension or Steering Systems Are Prone to Fail?
In In automotive usage, the term "suspension" refers to all of the parts that connect the vehicle to the road. Every car, truck, and utility vehicle has a suspension that is designed to do three things: Support the vehicle Absorb...
2007 Nissan Versa vs. 2007 Saturn Ion: Which One Should I Buy?
Compact cars as a class are generally meant to be commuter vehicles: with excellent gas mileage, an entry-level price point, and decent safety ratings for those who are on the road the majority of their time. These cars also make...
When to Replace Front Struts
Know the signs of front struts in need of replacement and when to take your car in to have them fixed.