Q: Not shifting and quit running - 2011 Honda CR-Z

asked by on September 23, 2016

My car has 60,500 miles on it, and I started having problems going it into 1st gear. When I slightly released the clutch a tiny bit and sometimes when I put it into 4th gear it wouldn’t go into gear. But I didn’t worry about it. And it made a grating sound, too. This happened a few times a week at the most, and it didn’t get any worse. When I was driving on the freeway yesterday my rpms were going up when I accelerated. I was in 6th gear and the shift indicator light came on, and told me to upshift. I pulled my car over to the shoulder of the freeway, opened the hood and smelled a burning smell. When I was just about home my car was barely running. I got there just in time. It wouldn’t even accelerate. The rpms just jumped. Do you have any ideas what I could do to get this working again? Could my clutch be completely burned out?

Car is hard to shift Inspection $94.99 - $114.99 Get a Quote

With your description of the problems, it sounds like your vehicle is having problems with the clutch slipping on the engine flywheel. 60,000 seems pretty early for this type of problem, but depends on the way the vehicle is driven. Have a professional inspect the hydraulic portion of the system as well as inspect the clutch assembly in order to diagnose the shifting problem.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I replace the remote control batteries?
Replacing the batteries in your vehicle’s remote control is no different than replacing them in your household remote control. Find the battery compartment on the back of your remote control. Slide the battery cover down and off. Remove the batteries...
Car starts, but doesn't stay started.
The problem you describe can be the crankshaft position sensor. The sensor is a major failure on these vehicles and can cause no starts or intermittent starts and stalls. Have a qualified mechanic test you car with an approved scanner...
Ignition system is not working.
When you are experiencing problems with starting your vehicle, we first want to address the life of the components that aid in starting the vehicle up. It was mentioned that you have a new ignition system installed and that it...
Changed camshaft sensor but car still won't start, could it be the crankshaft sensor?
Hello, thanks for writing in. Most of the time, this code comes up when there is a difference between the crank and cam sensors. The most common failure is the crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor). These fail much more frequently (https://www.yourmechanic.com/article/how-long-does-a-crankshaft-position-sensor-last)...
As I drive away there is a trail of petrol/oil left behind
Hello and thank you for contacting YourMechanic. If you can see a fuel trail behind your vehicle, yes it can be dangerous to drive the vehicle, depending on where the fuel is leaking from. Check under the vehicle to see...
My car has trouble code P0745, do I need to replace the solenoid?
Diagnostic Trouble Code P0745 refers to out of range voltage at a solenoid-operated valve that regulates hydraulic pressure in the transmission based on outputs from the Transmission Control Module (TCM). Code P0745 is set when the TCM sees an out...
When pulling off, it feels like the rear end is dragging
If a wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) in the hub was defective enough to cause drag, you would hear a tremendous amount of noise from the failed bearing. Wheels might also drag due to misalignment or failure of the brakes to retract....
I got oil changed n they told me I had metal in oil n two major oil leaks I got the car sept 24 from jd by rider of Greenville bk
Hello. Metal shavings or pieces in the oil pan can be a serious sign of major mechanic failure on the horizon. Did you personally see the metal shavings? Do you trust that this was an honest diagnosis? If so then...
Can you car still run if the ac compressor belt breaks
Hello. The car will not successfully run without a serpentine belt. The car may continue to run for a moment if the ac compressor belt breaks, but not for long. The belt also powers the alternator, which supplies engine with...

Related articles

A Buyer’s Guide to the 2012 Honda Accord
The The 2012 Honda Accord has a lot to offer. From great fuel economy to comfortable features and a sleek, modern look, it’s no wonder so many people love the Accord. Though, unlike the Civic, Honda has yet to offer...
2012 Honda Civic vs. 2012 Ford Focus: Which One Should I Buy?
One of the best ways to cope with pain at the gas pump is to look at downsizing your vehicle, and today’s compact cars are a great option that allow you to keep the space that you need to move...
The Best Used Cars to Buy if You Live Close to the Ocean
If If you live close to the ocean, your vehicle is going to be far more vulnerable to rust than if you lived further inland. And the fact is, when it comes to resisting rust, not all vehicles are created...