Q: My Chevy captiva 2013 jerks when in idle.

asked by on June 17, 2017

My Chevy captiva 2013 jerks when in idle. I've had my oil changed, filters replaced & my throttle body clean what's wrong? I have used a few different fuel cleaners but not all at once I thought It was the gas so I went with a brand name company but it still jerks. I step harder on my brakes but it does work either any suggestions?

My car has 87872 miles.
My car has an automatic transmission.

Car idle is rough Inspection $94.99 - $114.99 Get a Quote

There is a problem with one or more "engine management controls" or a mechanical problem. A scan tool, or engine scope, would reveal the underlying issue. Among the possibilities are uneven cylinder compression, sticking valves, a vacuum leak, an air induction fault like a stuck idle air control valve or a faulty throttle position sensor, problems with the mass air flow sensor, defective spark plugs, a weak coil and defective oxygen sensor(s). If you desire that this problem be diagnosed by a certified Mechanic, dispatched by YourMechanic right to your location, please request a rough idle diagnostic and the responding certified mechanic will get this resolved for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Paint in a really bad state, can it be fixed?
The reason paint on new cars chips more easily today than it did in the past is because the paint is more environmentally friendly. Traditionally, the majority of car paints were lead-based, but today paints are water-based, which increases the...
Seat heater not working.
Having an inoperative heated seat is not out of the ordinary. Most times the heater grid in the seat goes bad. Generally this happens over time just due to the fact that getting in and out of the seat flexes...
Car makes popping noise while turning
Hi there. If your car is making popping noises when turning or over inclines, there is probably a problem with the suspension. Common reasons for such noises may be, worn ball joints, worn suspensions bushings, or blown shocks. I would...
Car parts that get damaged while driving through water
When you drive through water (https://www.yourmechanic.com/article/how-to-check-for-water-damage-in-a-used-car), the electronic parts should really never get wet because it can damage them. But, with that said, the electronic power-steering systems are sealed pretty well from water. They have got seals all over. Unless,...
Key is stuck in the ignition and won't turn all the way back into the lock position
It is either the ignition switch electrical or the ignition lock cylinder. The key slides into the ignition lock cylinder. These two components mate together and essentially become one. So if either of them break, they will both be affected....
The car 166,000 miles on it, but still runs like a top...
Hello, thanks for writing in. the torque converter is the likely failure here. The torque converter drives the pressure pump for the transmission (which provides the hydraulic pressure for gear engagement, shifting, etc.). The torque converter splines are notoriously weak...
Steering wheel shakes.
What you are describing sounds like a problem with the rack and pinion gears. The rack and pinion gear set does two things: It converts the rotational motion of the steering wheel into the linear motion needed to turn the...
How do you replace the passenger power seat switch? Having a hard time taking off the Side panel that holds switch in place..
Remove the bolts that hold on the panel to the seat. Then you may have to remove the bolts that secure the seat to the floor to lift up the seat rail and gain access to the rail bolts to...
there is a loud rattling noise that sounds like its coming from transmission and only does it during acceleration and higher RPMs
It's possible the code(s) stored when the check engine light came on might provide some clues although your onboard diagnostics system is an early version (OBD-I) and so the data reported is not very detailed. Nevertheless, a first thing to...

Related articles

A Buyer’s Guide to the 2012 Chevrolet Tahoe
The The Chevy Tahoe has always been one of the most popular SUVs on the market, and this trend continued in 2012. As always, the vehicle proved to be reliable and powerful, with plenty of space and features that people...
2012 Chevrolet Malibu vs. 2012 Ford Fusion: Which One Should I Buy?
When you want a midsize sedan, you’re looking for something that will offer you the best fuel economy for the size as well as additional safety features that will keep your family safe while you’re driving across town or around...
The Top 5 Selling Cars in Alaska in 2012
Alaska Alaska requires a different kind of vehicle to handle both the terrain and the wintery conditions. While some of the most popular options for the Alaskan terrain in previous years included options such as the Subaru Forester and the...