Q: My car has no oil, the only oil I have available at the moment is 5w-30 but my car requires 5w-20 is it ok if I put it in? Will it

asked by on February 16, 2018

My car requires 5w-20 there is very little oil left and the nearest auto parts store in far away I live in the sticks. I have 5w-30 available. Can I use it without inflicting damage to me vehicle?
My car has an automatic transmission.

Change Oil and Filter $103.58 - $181.08 Get a Quote

5W-30 is perfectly OK to use on this vehicle on a temporary basis. The only detriment, and it will be hard to detect without complex measuring equipment, is the higher viscosity 5W-30 technically creates "pumping losses" in the engine which will lead to slightly reduced fuel economy. The 5W-30 oil is thicker and so it is harder to pump. With 5W-30 oil, there is no danger of inadequate engine bearing, valve train, or cylinder wall lubrication though. At your first opportunity, simply change back to the 5W-20. YourMechanic offers oil and filter changes during mobile visits right to your location and you can avail yourself of that service as the cost is lower and the service is much more personalized than at a shop or dealer. If you have additional concerns or a follow-up on this, don’t hesitate to re-contact YourMechanic.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I use the child restraint tether anchors?
Depending on your exact model, your vehicle is equipped with either two or three child restraint tether anchors. Many child restraint systems rely on tethers. The anchors in your car are on the back wall of the cabin. Attach the...
Doorlock and door opener broken
It sounds like the door latch needs to be removed and replaced. The door latch and locking mechanism are built into the same part and can easily be replaced. I would recommend having a technician from YourMechanic come out and...
Put a water pump and timing belt on it and alternator it crunk up for 20 seconds and cut off now it wont start but does tirn over
Assuming the vehicle was running before the timing belt was replaced, I have to ask, are you sure you lined up the timing marks correctly? This would be the first thing I would check myself if I were working on...
My car has been jerking and wont accelerate.
Hello there, thank you for asking about your 2004 Suzuki Forenza. You have a few different faults going on with your car. If you have a 1+2 shift malfunction there are a few potential causes. The most common cause is...
I put my car in reverse and push the gas but my RPMs won't read
This may be a sign of low transmission fluid or a faulty transmission control solenoid. As you may know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...
just replaced wheel bearings on a 2011 ford focus due to a grinding sound. also rep!aced brake pads both pads and bearings on fron
Hi there: I've seen quite a few Ford Focus' have internal issues with CV joints and transmission components that cause a similar "grinding noise" as a wheel bearing or worn out brake pads. However, before you take your car to...
Does extreme cold weather cause a car to heat up so fast,temperature gauge getting to the top
Hello, thank you for writing in. If you have only water in the radiator, and no antifreeze then more than just overheating (https://www.yourmechanic.com/services/brakes-steering-and-suspension-inspection) can happen Often the freeze plugs in the engine will pop out causing issues, the engine block...
My car has had trouble down shifting. Usually starts after a few minutes of driving. Codes: P07A4 and P2701
Hi there. On your transmission there is an actuator (solenoid) for the Overdrive clutch. The code is coming as P2701 (https://www.yourmechanic.com/article/p2701-obd-ii-trouble-code-transmission-friction-element-b-apply-time-range-performance-by-jay-safford) for the Overdrive clutch actuator (solenoid) not working and is your main cause of the transmission shifting issue. The...
I have no 3rd or 4th gears
Hi Robert. We understood your inquiry correctly the first time you submitted the question. The truth is that without completing an onsite inspection, telling you the exact reason why you are not getting third or fourth gear to shift is...

Related articles

2012 Nissan Rogue vs. 2012 Ford Escape: Which One Should I Buy?
Sport Utility Vehicles (SUVs) use the chassis of a truck to provide superior structure, with a larger size and often poor gas mileage. While that isn’t always true, SUVs have a raised ground clearance and are generally meant to haul...
The Best Used Cars to Buy for First Time Car Owners
Owning Owning your very first car is an exciting time in a person’s life. Likely you want to put a lot of thought and research into the process to ensure you get something that meets your needs, is fun to...
The Best Used Cars to Buy If You're a Carpenter
If If you're a carpenter, and working for someone else, the best used car is whatever you like that gets you to work on time and holds your tools – in short, practically any used car will do. If you...