☰
GET A QUOTE

Q: Misfire

asked by on October 15, 2016

My rpm gauge bounces around, doesn't rev when it does, it just bounces. Have a slight popping noise when idle or driving. Popps more when fast exceleration. Not so bad on highway. Compression test is good. I have changed plugs, wires, cap, rotor, fuel filter, idle air control valve. Still have problem. What would be more likely, map sensor or injectors?

My car has 233000 miles.
My car has a manual transmission.

Recommended Services

Electrical components are not working Inspection $94.99 - $114.99 Get a Quote
Noise from engine or exhaust Inspection $94.99 - $114.99 Get a Quote
Or For Any Other Auto Repairs Get a Quote

Hi there. From the description you have given, your vehicle has a combination of problems. The erratic tachometer/rpm gauge could be at fault. The tachometer signal from the ignition module could be erratic and may also be the cause of your vehicle’s drivability issue. The popping noise has me concerned. Even though the compression test has passed. There is a possibility, an exhaust valve is not opening properly (ie; a worn camshaft lobe), pushing exhaust gas back into the intake manifold. This popping noise from the engine sounds like a popcorn machine. I recommend your vehicle’s problems be inspected and diagnosed by a certified technician from YourMechanic.

GMC
Noises
Misfire
V6-4.3L
1993
C1500
RPM (Revolutions Per Minute)
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

In First gear, not much power
A six cylinder engine running on only four cylinders would be a low power situation. The two cylinders that are not working would need to be checked, to see if the injectors are working. These vehicles have a history of...
Read more
What causes the engine to run rough and the engine to die when the accelerator is pressed?
Hello. You have covered most of the common parts that fail with the exception of the idle air control valve/module. This is a unit that works similarly to the mass air flow sensor as it regulates the air intake into...
Read more
Why are my wipers going off when I turn the turn signals on?
Hi, thanks for writing in. It appears that there may be an issue within the column. The controls for the wipers and turn signals are separate units, but are connected by a series of wiring within the column, and there...
Read more
Wouldn't start, just cranks. It's been happening since front end was damaged. Everything was fixed from the accident, what could it be?
Hi there. Check the airbag sensor in the front end of the vehicle. Since the airbag deployed when you hit a deer, the airbag sensor had to be compressed to make this occur. Make sure that the battery is disconnected...
Read more
Transmission swap 1997 Ford F150
Hi - the short answer to your transmission swap question is "maybe". There are 4 possible automatic transmissions between 1997 and 2000 for the F150 (E4OD, 4R100, 4R70W, 4R75E/W). There will be a metal tag on each transmission indicating which...
Read more
Car revs up but does not drive faster than 40 mph on a flat road.
Hi there. For the engine revving up and the vehicle slowing down, the transmission could be slipping. Check the transmission fluid and see if its full and red in color. If the fluid is full, then the transmission could be...
Read more
My oil pressure is low light came on
The oil pressure light will usually come on when a few things could be happening. Either the motor is in fact low on oil, the oil pump could be failing or the oil pressure sending unit (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) is not working...
Read more
Is there vibrations and humming that gets louder when speed is increased then stops when vehicle stops a wheel bearing problem
From what you describe it is the front wheel bearings in the front hubs that need replaced. You should also check the tires for uneven wear and need for tire rotation or alignment issues causing uneven tire wear.
Read more

Related articles

A Buyer’s Guide to the 2012 GMC Sierra
The The 2012 GMC Sierra may not have sold quite as well as the Ford F-150, but that doesn’t mean you should dismiss this rugged and reliable model. For one thing, the Sierra is available in a half-ton version (1500)...
Read more
A Buyer's Guide to the 2012 GMC Yukon Hybrid
The The GMC Yukon is about as big and powerful as any SUV can ever get. However, in the past, that also meant paying a large sum every time you hit the pump. GMC has addressed this problem with their...
Read more
How Long Does a Top Dead Center (TDC) Sensor Last?
The The top dead center (TDC) sensor is the point from which the firing order is determined and the ignition system measurements are taken. The measurements are normally defined as before top dead center and after top dead center. The...
Read more

Browse other content

Cars
Cities
Estimates
Services