Q: It sequels and truns off

asked by on November 29, 2016

My gauge said my oil was fine I ran out of gas filled it back up then it still would not start the batteries cables where hot so I checked the water and then the oil and the stick had nothing on it then I put oil in and it squeals and turns off
My car has a manual transmission.

Car is not starting Inspection $94.99 - $114.99 Get a Quote

Hello. From what you describe it would appear that your vehicle may be experiencing more than one issue. A vehicle that does not start can be caused by a variety of reasons. If the issues began after the vehicle ran out of gas then it may be possible that the fuel system needs to be primed properly or that one of its components may have failed. If the battery cables are hot, then this may be a sign that the cables may need to be replaced, perhaps due to excessive resistance. In some cases hot cables can also be caused by a bad battery or alternator. If the engine is squealing when you crank it then that may be a sign that the serpentine belt may be loose, perhaps due to wear or a an issue with the tensioner. As it appears there is more than one issue that needs to be addressed, I would recommend having a professional technician come to your location to diagnose the cause of the no start condition, and proceed from there.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What does the traction control system (TCS) off light mean in a 2012 Chevrolet Equinox?
The traction control system (TCS) off light is located on your instrument panel. When the light is illuminated, it means that the TCS/StabiliTrak button has been pressed to turn off the traction control. Tip The TCS off light will briefly...
AC fuse keeps blowing
I would try and disconnect the A/C compressor to see if the fuse still blows (https://www.yourmechanic.com/article/how-to-check-fuses-by-rocco-lovetere). The compressor is the only thing that gets energized in all settings except economy. If this works and the fuse does not blow, then...
Code P0705 - 2008 Ford F-150
As with most diagnostic trouble codes, code P0705 (https://www.yourmechanic.com/article/p0705-obd-ii-trouble-code-transmission-range-sensor-circuit-malfunction-prndl-input-by-blake-griffin) does not necessarily identify failed parts. All you can assume with the code is that the PCM is not getting the signal it "expects" from the switch - no signal at...
Car problems
It will depend on why you had the engine rebuilt? If you had the engine rebuilt due to overheating and coolant came out of your exhaust then you may have damaged the catalyst during this period by sending hot coolant...
I have to pump the gas to get the engine to turn over
Hi..if your vehicle is fuel injected (i.e., does not have a carburetor) by "pumping the accelerator" you are not giving it "extra gas" but rather you are admitting air (or more air) into the intake manifold. Pumping the accelerator on...
Transaxle makes a loud grinding noise when you accelerate
Of course, first check the fluid level to be sure it is not low but if you are already hearing significant noise, there is probably mechanical damage that will have to be repaired. The problem has to be evaluated during...
No start with fuel pressure regulator 2012 Nissan Juke
Hello - I believe you have a fuel supply problem, which may or may not be the fuel pressure regulator (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-pressure-regulator). Monitoring fuel pressure while the engine is being cranked, and while it's running, will help you determine the real...
I have a 1987 chevy blazer S10, replaced brake light switch still no brake lights, whats wrong?
There is either a wiring break or perhaps excessive voltage drop on the circuit, that is a high enough resistance to prevent the required voltage from reaching the bulbs. Whatever the cause of the circuit failure, a Mechanic would simply...
2008 jetta 2.5 jerks right before complete stop and jerks again when accelerating from stop
You will need to have the computer tested for codes to see if the throttle sensors are working properly and if the accelerator pedal sensor is working correctly. Once test is done and codes are received then a mechanic like...

Related articles

A Buyer’s Guide to the 2012 Ford F-350
With With Ford’s stiffest chassis to date, the 2012 F-350 is one of the most reliable heavy-duty pickup trucks on the market today. With the quiet cabin and plush ride, though, you’ll feel like you’re driving in the comfort of...
The Top 5 Selling Cars in Alabama in 2012
2012 2012 was a great year in Alabama for auto manufacturing, but that wasn’t the only bright spot. Vehicle sales in Alabama were also robust in 2012. Nothing much changed in terms of the vehicle types that were most popular...
The Top 5 Selling Cars in Arkansas in 2012
Arkansas, Arkansas, like many other states, has to deal with a wide range of weather, from the stifling to the icy. This means drivers need vehicles that can handle the heat while also helping them get through slippery conditions. In...