Q: I hear a loud noise upon start up but it’s only when starting for a few seconds

asked by on January 11, 2018

So I bought my 2013 Yukon Denali Hybrid used in May of 2017. I have since taken it to Mataga GMC 6-7 times with no luck for the same issue. Upon starting up (not every time) it makes a squelching noise for like two seconds and it’s loud and noticeable. They can’t figure it out however I’m not sure what it could be or if u have come across this question yet. I can say that it happens if I use my automatic key fob to start it AND if I insert in ignition so both ways. It doesn’t have anything to do with driving at all and doesn’t matter what the weather is like. (Some questions I’ve been asked before).

Thank you!

My car has 82500 miles.
My car has an automatic transmission.

Car is making a noise Inspection $94.99 - $114.99 Get a Quote

Among the possible causes of the noise you are describing are a glazed or slipping serpentine (or other drive) belt and a starter motor with a pinion drive gear that is not fully and immediately retracting from the ring gear on the flex plate when you release the ignition key. There are other possibilities though. If the noise is consistent (at every start), a mechanic will be able to pinpoint the location of origin. If you desire a diagnostic, please request service using YourMechanic’s vehicle noise diagnostic service request page and the responding certified mechanic will definitely find the origin of the noise. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What does the tire pressure Warning Light mean?
The tire pressure Warning Light is located on the instrument panel. If the light is solidly illuminated, then one of the tires is experiencing dangerously low tire pressure. Check your tire pressure and adjust as you need to bring them...
Shifting car to neutral before stopping in red light
The automatic transmission was not designed to do this and may cause internal damage. The transmission and engine help slow the vehicle down for you and you are putting extra wear on the brakes. Automatic transmissions (https://www.yourmechanic.com/article/how-an-automatic-transmission-works) are not designed...
Click sound when press gas pedal
This sounds like potentially a valve train noise which is normal upon start up. As the car sits for a period of time the oil moves down to the bottom of the motor. Upon start up, the oil takes time...
Car won't stay crunk
This may be a result of a dirty or failing idle air control valve. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds...
Car shaking and cutting off
Hello, thank you for writing in. The first thing we need to do is try and replicate the issue. If it happens when you turn into your driveway, then turning, a bump, or braking may be part of what starts...
Why does my V8 sound like a V6 some of the time in my 1982 Mercury Grand Marquis
Hello. I would need to hear how the engine sounds in order to be able to know what it may be doing. If the engine is getting hot fast but is not actually overheating then that may simply be a...
truck wont start unless its jump started. I have put in a new battery and still wont start and acts like the battery is dead.
You say the car will not start from your battery but will from a jump start. This tells me you have a bad connection between the battery and your cable clamp. Remove and clean with a wire brush inside connector...
p2716
The trouble code P2716 will set for many reasons other than there being a defective solenoid. Consequently, the only way to reliably predict that replacing the solenoid will clear the code is to test the solenoid directly per the procedure...
2006 Ford Fusion anti theft light is on and it’s the only thing that comes on when trying to start car
If the theft light is only light coming on then you may have a theft system issue. Try to jump start the battery to see if it helps? If not then you will need to have a mechanic like one...

Related articles

A Buyer’s Guide to the 2012 GMC Sierra Hybrid
When When you buy a truck – even a half-ton truck like a GMC Sierra 1500 – you expect to make a trade-off between hauling capacity and fuel efficiency, right? Well, the designers and engineers at GMC don’t think that...
A Buyer's Guide to the 2012 GMC Yukon XL
When When you want a huge vehicle with plenty of luxury inside, you’re probably going to be happiest with the 2012 GMC Yukon XL. Key Features The 5.3-liter V8 engine on this full-size SUV isn’t surprising, but its fuel economy...
How to Get GMC Dealership Certified
GMC car dealerships offer automotive technician jobs to mechanics who are certified through one of the many programs they have available.