Q: I have an 04 Chrysler Sebring convertible with 2.4 liter engine. What size caliber bolts do I have on my front brakes?
I have a 2004 Chrysler Sebring convertible 2.4 engine what size caliper bolts do I have on front brakes and what do I need to remove those two caliper bolts
Recommended Services
| Brake Caliper Replacement | $222.57 - $1200.97 | Get a Quote |
Hi there. The caliper bolts that are on your vehicle are an 8 mm Allen head design, which can be removed with an 8 mm socket on a 3/8 or 1/2 drive socket drive set. If you need further assistance with replacing your calipers, then seek out a professional, such as one from Your Mechanic, to help you.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do I increase the cruise control speed?
Once the cruise control is set, you can increase the speed in two different ways: 1. Press and hold the Resume+ button. The car will accelerate while you hold the button, and you can release the button when you reach...
Slave cylinder leaking
The hydraulic system used on your Honda is the same as your brake system. If there are leaks in the system and air in the lines, the pressure plate cannot be engaged or disengaged which is required to operate the...
Car windows going down, but not up
Hi there. The power windows in your car are computer controlled. They have safety features such as anti-trapping windows. It’s highly irregular that both or all four windows stopped going up at the same time. But when presented with weird...
My speedometer needle starts under zero, so when I'm going 40, my speedometer shows 20
Hi, thanks for writing in. The issue you describe indicates that the speedometer needle is now misaligned on the gauge shaft. This can repaired by a knowledgeable speedometer repair facility. The instrument cluster (with the speedometer) must be removed from...
Oil drain bolt leaking
Hi there. Unfortunately, these things do happen as the oil drain plug is removed and installed many times during the life a vehicle. Was there a drain plug gasket on the drain plug you installed? If not, this will definitely...
2008 Ford F-150 no reverse
You may have broke the reverse band inside the transmission and would require the transmission to be taken apart to replace the broke part.
2008 lexus gx470: car bouncing even after $3500 shocks were replaced on front and back
If the ride height is within spec, that is the coil springs are not weak, the only cause of the vehicle failing to settle immediately (i.e., bouncing) after encountering road irregularities is defective shocks or defective strut assemblies with built...
I just replaced my alternator in my Toyota. My car starts up fine but I notice when I’m driving that out of no where I push the
Hi Kyle. Thanks for contacting us today. I'm not sure whether or not the alternator replacement has anything to do with this symptom. However, it is possible that during the removal, an electrical fault may have disabled a transmission speed...
Steering wheel won't turn
It is unclear if you are referring to a locked steering column versus a circumstance where there is loss of power assist or perhaps failure of a steering linkage that is causing the steering wheel to bind. Regardless of which...
Related articles
How Long Do Brake Shoes (Rear) Last?
Most Most of the older cars on the market have two different types of brake systems on the front and rear of them. Generally, the front brakes will be pads and rotors, while the back will be drums and shoes....
How to Replace a Brake Hose
Modern Modern cars use a combination of metal lines and rubber hoses to contain and transfer the fluid that applies your brakes. The lines coming out of the brake master cylinder are made of metal to be strong and long...
How to Change Front Brake Pads
Brake pads are failing when the brakes are noisy, the brake pedal pulsates when pressed, or there is poor brake response when the pedal is pressed.
Browse other content
Cities
Estimates
Maintenance