Q: how would an engine run if a mass air flow sensor signal was too low?
how would an engine run if a mass air flow sensor signal was too low/high?
A mass air sensor with low output voltage may cause loss of power, hard starts or rough running.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car not starting
Hello! A slave or master cylinder malfunction will not cause a no start condition. I suspect there may be an issue with the clutch pedal sensor. The sensor is made to disable the vehicle from starting until the clutch is...
did not pass smog test. obd catalyst, oxy snsr heat not complete.
Hi there. If your Check Engine Light is not illuminated, there is not a fault with the system. Before a vehicle can pass emissions testing, certain readiness monitors must be completed. One of which is the heater O2 monitor. The...
When putting foot on accelerator, brake, or shifter, car dies
A few different faults can cause the vehicle to go into a limp mode. The ECU puts the car into this mode to prevent damage and will be associated with a Check Engine Light. The most likely causes are a...
Rear differential noise
The noise is not coming from the pinion seal, but the pinion bearings are bad and this is why the pinion seal is leaking. You will need to have the rear end bearings and seals replaced (https://www.yourmechanic.com/services/pinion-seal-replacement). If you'd like...
Multiple new problems after collision repair
When there are problems that were not there before an accident that show up after repairs are done, then the problems may have been due to the last repairs. However, you know best if any of the problems are new....
How much would it cost to replace a fuel pump on a 2006 GMC Canyon truck offroad
Hi there. You can drop the fuel tank from the bottom of the vehicle to get to the fuel pump. It would require removing the fuel neck, fuel vapor lines to the canister, the electrical harnesses, and the fuel tank...
How much does it cost to replace two doors on my 2006 Ford Taurus.
Hi there. The cost of replacing the doors can vary tremendously based on what kind of damage occurred to the door jams and what model doors the vehicle has. If there is damage to the mounting of the doors then...
2000 Jeep Cherokee overheated and won't start
Hi there. If the vehicle overheated, and you noticed a lot of coolant on the ground, it's quite possible that either the radiator broke, a coolant hose broke or the radiator cap was damaged. When this happens, a lot of...
What do P shift mean on 2015 jeep Cherokee
The P indicates you are in paddle shift mode and need to shift down. You can disable paddle shift and put in drive mode by holding the + plus button until D or S is displayed.
Related articles
How Long Does a Steering Angle Sensor Last?
Once Once upon a time, your car’s steering system was pretty straightforward. Today, this isn't really the case. As more and more electronic systems are added to our vehicles to enhance stability, control and maneuverability, the systems inevitably become more...
How Long Does a Timing Chain Last?
A timing chain is a metal chain, as opposed to the timing belt which is made of rubber. The chain is located...
P2712 OBD-II Trouble Code: Hydraulic Power Unit Leakage Intermittent
P2712 means there is low pressure usually caused by a leak in the the hydraulic power unit or also faulty sensors & solenoids or electrical issues.
Browse other content
Estimates
Cities