Q: How to hook up the shift cable.
I'm trying to hook up my shift rod to my transmission and when I get it to go in the gear salecter won't go into drive just park reverse and netral
My car has 60000 miles.
My car has an automatic transmission.
The kickdown cable is too tight and needs to be back off. The kickdown cable controls the throttle valve on the transmission which overrides the transmission shifting. If the cable is too tight, then the transmission will not shift and may not go into drive. If you need further assistance with your kickdown cable, then seek out a professional, such as one from Your Mechanic, to help you.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Plastic key in ignition
Hello, The metal key and plastic housing both need to be intact for the vehicle to start. The plastic housing holds a computer chip which sends a signal to the anti-theft system to start the vehicle. The metal key acts...
Car shifts roughly and jerks
There is most likely a problem with one of the sensors on your engine. Depending on which sensor fails, and how it is failing, signals may be sent to the computer that can make the transmission shift harder because it...
Adding cruise control on a factory non equipped car.
The unfortunate truth is the dealer is correct. What you are doing is in theory feasible but not common at all. I haven't run across anyone who has done what you are doing and I have often wondered how such...
What does p1494 code mean?
The code is to the EVAP leak detection pump problem by the right front headlight. The pump or switch is malfunctioning. I recommend having a mechanic diagnose the code for you. The code P1494 is the same as code TC184A...
2011 Ford Transit Connect overheats, AC blows warm
Hello. Thanks for writing in about your 2011 Ford Transit Connect L4-2.0l. I have ran into so many of these vehicles with blown head gaskets. They can be hard to diagnose if they are not tested during the overheating. A...
Will I pass my MOT if the dephaser pulley is failing renault megane vvt 1.6
Hello. If your vehicle's dephaser pulley is having issues, it may have a dramatic effect on the engine's emissions levels, which are a part of the MOT test. The MOT test looks at safety, roadworthiness, and exhaust emissions levels. The...
Stability Light came and Check Engine Light came on. I have a misfire on number 6 plugs.
Your car is equipped with wheel speed sensors at each of the four wheels which monitor wheel speed while relaying this information constantly to the ABS and traction control system which are controlled by the car's ECU. When the ECU...
Engine dies for a second when traction control light comes on
Hi There, The traction control system monitors the steering stability of the vehicle and engages when loss of traction has been detected. This is done by the use of electronic sensors at each of the four wheels that communicate with...
Brakes
It is not normal for the brakes to pulsate after replacing the rotors. You will need to determine if the pulsation is coming from front replacement rotors or from the rear brakes that were not replaced by using the parking...
Related articles
A Buyer’s Guide to the 2012 Chevrolet Sonic
The The 2012 Chevrolet Sonic is not only the only domestic subcompact sedan (or hatchback) on the market today, but it’s also one of the most versatile models in its class. This entry-level subcompact car – available in both sedan...
The Best Used Cars to Buy If You’re Single
When When you’re buying a vehicle that needs to meet the requirements of all kinds of passengers the process can prove to be rather tricky. However, if you happen to be single, you’re the one in control, and your list...
Symptoms of a Bad or Failing Kickdown Cable
If you feel that your car's transmission is shifting roughly, too fast, or too slow, you may need to replace the kickdown cable.
Browse other content
Maintenance
Cities