Q: How many oxygen sensors do I have on my 2008 Cadillac Escalade EXT?
I'm not sure if my truck has 1, 2, 3 or 4 oxygen sensors.
My car has 118000 miles.
My car has an automatic transmission.
Recommended Services
| Oxygen Sensor Replacement | $123.80 - $932.74 | Get a Quote |
Hi there - your Escalade has 4 oxygen sensors total, 1 before each of the two catalytic converters, and 1 after each catalytic converter. Diagnostic codes are usually pretty specific as to which one is malfunctioning (i.e. Bank 1, Sensor 2 for example). For assistance with replacement, I recommend an oxygen sensor replacement performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, and give you an accurate assessment of damage and cost estimate for repairs.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Trouble starting in the morning.
Trouble starting in the morning could be a sign of worn secondary ignition components; spark plugs, wires, cap and rotor. As for the shaking and jolting the first thing I would suspect would be motor/trans mounts that have torn and...
Car making clunking noise in rear
Along the vehicle, the drivetrain has many mounting points and suspension components to help the vehicle perform. These mounting locations generally include hydraulic and rubber mounts, which are considered maintenance items, as they do wear under stress. There are many...
Clunking noise from front of car when driving slowly or turning slowly
Hi there. Most clunking sounds, especially while turning, are attributed to worn out bearings or bushings - especially CV joints, tie rod ends, and also stabilizer bar joints (https://www.yourmechanic.com/article/symptoms-of-bad-or-failing-stabilizer-bar-bushings). Not sure why it would only happen while it is hot...
Engine was just replaced in my car but the check engine light is on. Is this something that has to be reset by driving the car?
The Check Engine Light is on if the light was not reset after work was done, or it came on again due to encountering another problem. If you just had the engine replaced, then have the system scanned to see...
I have a illuminated Service AdvanceTrac Light and my back passenger rotor is destroyed within minutes of me driving after installation
Hi and thanks for contacting YourMechanic. The AdvanceTrac will need to be adjusted for the height difference. As for the rotor being destroyed after putting on the lift, check the caliper to see if the line to it is long...
Car will turn left but not right. I was told by a shade tree mechanic it can be welded back to the frame is this true?
Hi there: If the steering rack has broken off the mount, the mount would have to be welded and repaired first. The pinion gear is a part of the steering system that turns as the steering column sends input to...
98 camry starter clicking and the battery and starter is good.
Hi there. Check the battery cables (https://www.yourmechanic.com/services/service-battery-cables) and make sure that they are tight and clean. Check the battery for a load test. The battery should not drop more than 11.5 volts during a voltage drop test. If the battery...
Timing marks does not come back to TDC after I hand rotate it on a 5.4 2006 Triton.
When rotating the crankshaft and turning the engine over, the camshafts will realign after the crankshaft has turned twice. Now, the marks on the timing chains will take around 15 rotations to line up on the timing marks on the...
My truck turns off even after i have started it
You haven't said whether it can be restarted and driven, so I don't have a lot to go on. But one thing you can easily check for is vacuum leaks. Any air that gets into the engine without going through...
Related articles
Symptoms of a Bad or Failing Crankshaft Position Sensor
Common signs of a faulty crankshaft position sensor include issues starting the vehicle, intermittent stalling, and the Check Engine Light coming on.
Symptoms of a Bad or Failing Manifold Temperature Sensor
Common signs include a rough idle, lack of power, high NOx production, and emissions test failure.
How to Replace a Cylinder Head Coolant Temperature Sensor
Signs of coolant temperature sensor failures include sluggish acceleration, hard starting, and a Check Engine or Service Engine Soon Light.
Browse other content
Services
Cities