Q: How do I reduce the cruise control speed?

The engine in these vehicles have too many possible problems to give you one or two but more than a dozen possible causes for the runs rough lack of power. I will give you the top two that stand out...

Hello. This can be a dangerous issue and does happen on this vehicle. Typically I have repaired this with updating the computers in the vehicle. Some of the time when the degeneration is not working correctly it is because the...

Hello. Thanks for writing in about your Infiniti EX35. It sounds like one of your sensors for the system is reading incorrectly. I usually check the tires (https://www.yourmechanic.com/article/how-to-check-if-your-tires-are-in-good-condition) first as an odd tire on the car will cause this. If...

Hi there. Assuming you replaced the TCM (transmission control module) with a factory part, a transmission shift relearn procedure should have been performed. It could be that you have a TCM connector or wiring issue if the same code has...

Hi and thanks for contacting YourMechanic. The AdvanceTrac will need to be adjusted for the height difference. As for the rotor being destroyed after putting on the lift, check the caliper to see if the line to it is long...

If you remove the oxygen sensors from your vehicle, you will ruin the efficiency of the engine, thus consuming around 10 to 20 percent more gas than otherwise required, and also cause early failure of many components such as the...

The two Diagnostic Trouble Codes, P0304 (https://www.yourmechanic.com/article/p0303-obd-ii-trouble-code-cylinder-3-misfire-detected-by-spencer-clayton) and P0302 (https://www.yourmechanic.com/article/p0302-obd-ii-trouble-code-cylinder-2-misfire-detected-by-jamahl-walker), refer to cylinder misfiring. A faulty ignition coil, spark plug, wire, and so forth can cause a cylinder to misfire but there are other possible causes, too. Consequently, the only...

This may be related to a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at...

Check the wiring to the fuel pump and make sure that it is plugged in properly. The fuel pump will stop working if the wiring disconnects from the pump. If the wiring is connected properly, then the fuel pump relay...