I have a 2002 Honda Accord no spark just change the distr...


I have a 2002 Honda Accord no spark just change the distributor still no spark ...

I have a 2002 Honda Accord no spark just change the distributor still no spark

Automotive Expert
Hello, my name is \*\*\*\*\* \*\*\*\*\* to just answer! I will be assisting you with all of your vehicle questions today. I’m really sorry that you’re having this issue and I’m going to help you through it, but please understand that I (respectfully) don't know your skill level or tools you have to assist us to diagnose/repair your vehicle. Also, understand that I can't see, smell, hear or touch the vehicle either, so your patience/understanding is appreciated. Please allow me up to 10 minutes to gather schematics and other pertinent information for this issue. I do not know anything about the fees or charge so please if you have any concerns, direct them to customer service. My aim is to give you the best service possible and to help you. If you have any questions or concerns, please don’t hesitate to let me know. I appreciate your patience and will provide responses as soon as possible. Thank you. 4 or 6 cylinders?

44 cylinders
Automotive Expert
do you have 12 volts dc on the black/yellow wire at the distributor's connector with the key on?

I will check that when i get home from work
Automotive Expert
ok

No there is no power to that wire
Automotive Expert
ok. please standby while I finish up with 2 other customers. check fuse 11 on the panel under the left side dash
Automotive Expert
location attached

Its good
Automotive Expert
does that fuse have 12 volts at it? the key has to be on. also, did you have the key on checking at the distributor?

Hey bud i fixed the car but i got a little newer. I could use your help with
Automotive Expert
same car? and what was the issue that fixed it?

What others are asking

Car shuts off while going over speed bumps.
There may be a loose connection somewhere in the electrical portion of your fuel system causing the fuel pump to shut off. The relay may also have gone bad and the bump causes the internal metals to 'weld' themselves back...
What is a P013C code
This code signals an oxygen sensor slow response from rich-to-lean on bank 2 sensor 2. This indicates that when the computer cuts the fuel to test sensor output, it does not respond quick enough and the code is set. This...
what will happen if i drive on crunchy front berrings
Hello...it is wonderful to hear from a Tercel owner!! I owned a 1985 Tercel for 25 years!!! One day, on the freeway, the rust on the front sub-frame finally caused the car to basically "crack" where the control arm is...
Belts keeps breaking - 1992 Mercury Capri
Hello. If this all started after the alternator was replaced, then that is more than likely the problem. If the alternator is defective and has an internal bearing failure then this will occur. Also, if the alternator is not mounted...
Car won't start in the morning, but it starts perfectly throughout the day. 2005 Ford Focus
It sounds like your engine does not have fuel pressure held up to the injectors overnight. The fuel pressure is leaking down due to a bad fuel pump check valve, or the fuel pressure regulator is leaking down the pressure....
DPF (Diesel Particulate Filter) melted
Hello. The DPF functions by trapping certain diesel particulates, and periodically goes through a regenerative cycle to burn those particulates (i.e. when you're on the motorway and get the temperature high enough to regenerate). This is a bit speculative, but...
Why doesn't my door open from the outside?
To determine what exactly has failed, it will be necessary to remove the inner door panel and look to see what part(s) have actually failed. The most common failures, when an outer door handle quits working (https://www.yourmechanic.com/services/door-will-not-open-inspection), is a broken...
If my mechanic says I have dark brake fluid, do I need to bleed the brakes?
Hi John. Thanks for sending in your question today. With today's ABS systems, bleeding the brakes or flushing the brake system due to contaminated brake fluid is a very complex process that requires special tools to complete it correctly. If...