Q: Hello I have a Chevy impala 2013 the A.c. stopped blowing air a few days ago. Then an error code came up saying engine hot A.C. of

asked by on October 13, 2017

Hello I have a Chevy impala 2013 the A.c. stopped blowing air a few days ago. Then an error code came up saying engine hot A.C. off. However the temperature gage is where it should be. If you let the car sit for a few hours not on the error code goes away. Now the check engine light is on. Any ideas?

My car has 67000 miles.
My car has an automatic transmission.

Check Engine Light is on Inspection $94.99 - $114.99 Get a Quote

The resolution to this, and the answer to your question, will depend on exactly what trouble codes were stored when the check engine light (CEL) illuminated. To have the fault(s) that caused the CEL to illuminate pinpointed and repaired, please request a check engine light diagnostic and the responding certified mechanic will get that taken care of for you. Once the faults behind the CEL are resolved, the error message relative to the a/c system, if it remains, can be dealt with. The latter error message, that is "hot engine, A/C off" is a known issue in certain GM models (such as yours) and the reported fixes have varied from replacement of the thermostat to repair of faulty connections at the body control module. In your circumstance, inasmuch as the a/c fault is accompanied by illumination of the CEL, the latter should be addressed first as it is possible such will resolve all issues. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What does the electronic brake force distribution (EBD) Warning Light mean?
The electronic brake force distribution (EBD) Warning Light is located on the instrument panel., and is a combination of the anti-lock brake system (ABS) and standard brake system Warning Lights. When the EBD illuminates, there is an issue with your...
Truck creaking while driving
The noise is most likely coming from the upper or lower ball joints, or it may even be coming from the tie rod ends. These joints are commonly known to be develop noise as they wear and bind. I recommend...
I need the measurements for brake/shoe pads left and right front and rear wheels
Hi there, thanks for writing in. I have always recommended brakes to be replaced if the pads are worn down (https://www.yourmechanic.com/article/how-to-recognize-brake-pad-wear-patterns-by-cheryl-knight) to 4/32 of an inch and the rear brake shoes worn down at its thinnest point to be 3/32....
Front brake gets locked up - 1983 Jeep CJ7
Have the residual pressure valve for the locking brake checked for problems. Residual pressure valves maintain a very slight hydraulic pressure for each brake in order to make the brakes more responsive when you press the brake pedal. If it...
Rumbling when coasting - 2007 Chevrolet Trailblazer
Hello. A wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) going bad will definitely cause a rumbling or droning sound as you describe. This will generally get worse as you accelerate as more force is exerted on the bearing and it is caused to turn...
My Dodge Neon is misfiring on cylinder #4. The Check Engine Light is on, code is P0304.
A misfire can can also be caused by a vacuum leak, a wiring problem, a faulty fuel injector (https://www.yourmechanic.com/services/fuel-injector-replacement), a bad electrical connector, or any number of other causes. It would be best to pull the codes that are causing...
P0013 code
Hello. A code p0013 (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) stands for the variable camshaft timing solenoid voltage being out of range. This could mean low or high voltage. The variable camshaft timing is measured by a senor who's input is uses constantly by the...
The check engine light and the VSA came on at the same time. Is the van (Honda Odyssey 2010) ok to drive.
VSA is Honda's name for the electronic stability control system. Most vehicles today have it and use different names. The stability system usually piggy backs on the anti-lock brake system, using the same wheel speed, brake light, steering angle, and...
My 2015 Chevrolet Tahoe was running fine i added oil and when i turned the car on later that day it started shaking what could it be?
Hello. This would usually only occur if you added to much oil or used the wrong weight oil. This engine needs the correct oil in order for the valve timing system to work right. It sounds like the vehicle should...

Related articles

A Buyer’s Guide to the 2012 Chevrolet Colorado
The The 2012 Chevrolet Colorado is the perfect size pickup for running errands on the weekend and doing light duty chores around the yard. For those who don’t need a full size pickup, the Colorado offers almost everything a full...
A Buyer’s Guide to the 2012 Chevrolet Impala
A A true classic, the 2012 Chevrolet Impala may not have all of the latest high-tech features of other sedans on the market, but it is a tried-and-true model with lots of room, plenty of comfortable features, and a large...
A Buyer’s Guide to the 2013 Dodge Dart
It’s It’s back, and better than ever. In the first incarnation of the iconic Dodge since 1976, the Dart has been updated, beatified, and turned into a compact force to be reckoned with. This zippy little machine is tough to...