Q: Head set changed to spanis. I need english

Hi there. It sounds like you have a couple of different problems. If the vehicle does not have much power going into reverse, but the engine revs up fine then the transmission is slipping. Reverse is typically the first gear...

Hello. I would have the engine oil pressure checked immediately. Having the correct oil level isn't enough if the engine is unable to maintain sufficient oil pressure. It's possible the coolant level (https://www.yourmechanic.com/services/coolant-level-sensor-replacement) and oil pressure sensors (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) are faulty,...

Brake noise or chatter occurs when the brake pad backings vibrate in the pad guides and caliper housing. Often the application of a brake grease or anti-seize lubricant can be applied to the contact point of the brake pad (https://www.yourmechanic.com/services/brake-pads-replacement)...

Hi there, thank you for asking about your 2003 Mercedes-Benz S55 AMG. This is usually caused by a failing throttle body. The throttle motor or sensor fails and will cause this to occur. If the motor cannot move the throttle...

You most likely bent the wheel spindle or strut [https://www.yourmechanic.com/services/strut-assembly-replacement] causing the top of the wheel to bend in toward the strut spring. You should have the wheel, strut, lower control arm and spindle to identify what component get damaged....

A fault code p0304 is typically caused by a faulty plug or a failed ignition coil. If it has been quite a while since there has been a tune up done, I would start there. Many times a misfire can...

Hi there, there are actually several additional components to check for blower motor operation (https://www.yourmechanic.com/question/heater-does-not-work-by-todd-d). First is fuses - easiest and least expensive to test. There is a blower motor relay, and also one or motor blower motor resistors, and...

Hello - it sounds like the 4WD-High actuator is not successfully engaging High-range (https://www.yourmechanic.com/question/4wd-not-working-just-making-a-clicking-nose-by-jacob-c) as expected. There are many possible causes, bad servo actuator, transfer gear mis-alignment, transfer shift fork wear. For assistance, I would recommend transfer case inspection (https://www.yourmechanic.com/question/4wd-will-not-engage-by-danielle)...

Hi there. Most of the time when this occurs it is due to a lack of voltage. It can be from a failing battery or alternator. Most of the time the issue is the battery. If the voltage is dropping...