Q: Hazards work but turn signals don't. Replaced the circuit boards relay and bulbs. I have a 99 Grand Cherokee.
Replaced relay fuses and bulbs still no turn signals but the hazards work
My car has an automatic transmission.
Recommended Services
| Hazard / Turn Signal Flasher Replacement | $107.05 - $283.85 | Get a Quote |
If the relay and fuses were replaced check to see if the flasher is working. If there is power to the flasher but nothing past the flasher, then the flasher needs replaced. If there is no power to the flasher but the relay and fuses are good, then the Hazard light switch has failed. If there is power before and after the flasher but there is no power to the bulbs, then there is a break in the wiring or a loose or corroded ground wire. If you need further assistance with your Hazard lights not working, then seek out a professional, such as one from Your Mechanic, to help you.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
rubbing or rotating type of sound from rear wheel passenger side
Hello there. A few potential problems could cause a rubbing noise from the rear of the vehicle. The most common would be the wheel bearings (https://www.yourmechanic.com/services/wheel-bearings-replacement), brake drum (https://www.yourmechanic.com/services/brake-drum-replacement), dragging parking brake (https://www.yourmechanic.com/services/parking-brake-is-stuck-inspection), or damaged wheel. If you want to...
My ac went out can I bypass the ac pulley with a shorter belt
Yes, this is possible. However, unless it was the AC compressor clutch and pulley which failed, bypassing the AC pulley is unnecessary. Simply disconnect the wire to the AC compressor clutch and that should do the trick. The AC clutch...
When car runs awhile it will stall. The engine will turn on but as soon as you put it into drive it stalls.
Hi there, thanks for writing in. Any number of things can cause an engine to stall. Assuming, the Check Engine Light is not coming on, leads me to believe the ECM (Engine Control Module)/computer is not recognizing the fault. The...
Van not blowing hot or cold air 2006 Chrysler Town & Country
Hello - the lack of fan functionality (https://www.yourmechanic.com/article/what-components-of-the-heating-and-ac-system-are-most-likely-to-fail) in the front only of your van could be caused by either the front fan, the fan control switch or the front fan motor resistor pack failing. If the front fan works...
My car key won't turn in the ignition
A number of things can make the ignition difficult or impossible to turn. A faulty ignition switch or ignition tumbler may not signal the shifter interlock properly, preventing the ignition from turning. Also, a damaged,loose, or misadjusted shifter mechanism can...
Air is stuck In the defrost position
It is unfortunate that this has happened on such a new car. On the outside chance, it may just be a stuck button. If dirt or sticky liquids like soda or coffee ever got behind it, that could be making...
Significant vibrations after new rims and tires installation.
Unless you were previously able to operate at 90 MPH with no vibration, I would not necessarily expect such success now with the new tires and wheels. Once you get up to speeds like that, there are lots of possible...
Abs module is no good. I have another one from junk yard with the same year and FWD and engine. Will it work?
Hi there. As long as the ABS module is the same design and has the same ports on it then it will work just fine on your vehicle. Be sure to bleed all of the brake lines after replacing the...
The Diver side panel under the door is lose
Hi there. In order to help provide some tips or ideas, we need to know the make, model and year of your vehicle, along with some more specifics about the actual parts that are loose. If it's the floor board,...
Related articles
Can My Car Use Universal Switches?
Each Each system on your car is controlled by a switch. The ignition and starting system are controlled by the ignition switch, your power windows and door locks are operated by switches, your heater controls have buttons and switches, and...
What Are Lever Switches and How Are They Used in Cars?
Every Every electrical system in your vehicle is controlled by a switch in some way. Power window switches, headlight switches, and turn signal switches all perform an electrical function. When it comes to controlling bigger systems inside your vehicle, they...
Symptoms of a Bad or Failing Cruise Control Switch
If you use cruise control and the light doesn't illuminate or the car cannot maintain a set speed, you may have to replace the cruise control switch.
Browse other content
Cities
Maintenance