1999 ford explorer wont shift in reverse or shift in driv...


1999 ford explorer wont shift in reverse or shift in drive. It will shift in 2. Mechanic's Assistant: How old is the [transmission](/topics-transmission-ford/)? Have you noticed any leaking? No leaking and I bought used a...

1999 ford explorer wont shift in reverse or shift in drive. It will shift in 2. Mechanic's Assistant: How old is the [transmission](/topics-transmission-ford/)? Have you noticed any leaking? No leaking and I bought used about 3 yrs ago. So I am not sure how old it is. Mechanic's Assistant: Are you fixing your Explorer yourself? What have you tried so far? Putting transmission fluid in it Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Also about 3 days ago the overdrive light started blinking when you drive it over 70, but would turn off if you stop the car and turn it off and back on

Automotive Expert
Good Morning If it wont drive in reverse then the Transmission will need to be removed and rebuilt. If it drives but gears don't shift then sometimes it can be repaired The OD light blinking indicates that there are transmission codes being set

Ok, thank you
Automotive Expert
No problem , let me know if you have any other questions

What others are asking

What do the seat belt Warning Lights mean?
The seat belt Warning Lights are located on the instrument panel. When you or the front passenger are not wearing a seat belt, this light will illuminate, and be accompanied by a chime. When the belts are properly buckled, the...
How do I use voice recognition to store numbers?
The infotainment system can store up to 30 numbers at a time. You can add numbers to the system at any time, using voice recognition: Press the voice command button. The system will prompt you by saying “Ready”, followed by...
My car will lock and unlock by itself.
I initially would have your battery and alternator tested. Next I would try leaving the key fob away from the vehicle to ensure that is not the cause. If the battery, alternator and key fob do not fix the issue,...
Bad idling after coolant temp sensor replacement
If you have a bad knock sensor, then the engine timing may be going too low and causing the low rough idle. If the scanner gives a code, then have it diagnosed and fixed. A vacuum leak will also cause...
Should I flush previous antifreeze fluid before adding new fluid?
The antifreeze in the car now is most likely the original coolant. When changing your coolant you need to make sure that you are using coolant that meets or exceeds the vehicle specifications. Your cars antifreeze is a special long...
Poorly running engine.
Hello. Thank you for writing in. The fuel delivery system may very well be the cause of your problem. However, simply raising up the vehicle will not stop the fuel from flowing to the engine. This is not your issue,...
Where are the 02 sensors located on my 2010 Ford F-150 5.4L
This vehicle engine has 4 O2 sensors. They are all located in the exhaust system. There is one near each exhaust manifold and they are labeled HO2S1-1 and HO2S 2-1. Then there are two after the catalysts down further in...
2003 Jeep Liberty check engine light power all time smell and white smoke
Hi Vanesa. Thanks for writing in tonight about this very odd issue with the Jeep. Generally speaking, when you have constant power being drawn (even if the key is out of the ignition) it's caused by an electrical circuit that...
Car stalled and all lights turned on
Depending on how bad the catalytic converter is, a bad catalytic converter can cause the engine to run bad and even stall out at times. The reason that all the lights came on on your dash is because the engine...