Q: Experiencing shift shock from 1-2 and a little from 2-3 when car is cold.

asked by on February 09, 2017

I just bought this 2008 Mazda 3s from a dealer. I've noticed when the car is cold it shifts hard (shift shock) mainly from gears 1-2 and a little bit from 3-4. The problem improves when the car reaches operating temp. The problem is mainly from first to second gear. It feels a bit sluggish in first and jumps into second. Feels like it struggles to cross the threshhold to second gear. Not a huge jump into gear but very noticable. No thunking sound or anything, just feels like it struggles going into second while cold. I took it in but they obviously don't want to deal with a transmission issue. I've researched to find that others have had this same issue but can't find anyinfo on whether it leads to bigger problems, or any final diagnosis. To get the dealer to look at it I need to leave it so they can test it out when it's cold. If it's not under warranty I'll have to put out money for diagnosis, rental car etc.. Does anybody have advice on this?

My car has 114000 miles.
My car has an automatic transmission.

Hi there. It really depends on the terms of your purchase as to what I’d recommend. If the vehicle is under warranty then it’s best to let the dealership make the repairs. However, if it’s not, it would probably be a good idea to have this issue resolved by a transmission specialist shop (as they will typically be 20% lower pricing than a dealership). The issue itself could simply be due to an obstruction within the hydraulic lines inside the transmission, which can usually be resolved by a transmission fluid flush. You might want to start here, by having one of our professional mechanics complete a transmission flush and filter replacement.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What is the vehicle stability assist system?
Your car offers a number of pretty advanced systems designed to help provide better handling and safety on the road. One of those is the vehicle stability assist (VSA) system. Here’s what you need to know about it: The VSA...
Jeep revving, hesitating, and jerking
The symptoms you describe on your Jeep Grand Cherokee lead me to believe that you may have a cam or crankshaft position sensor intermittently failing. If the computer does not know the location of the cam and crankshaft, then it...
Truck making a knocking noise .
Hello. You should contact a certified mechanic before running the engine anymore, to avoid any further damage or causing an unsafe driving condition. They should have the specialty tools and techniques to properly diagnose the problem. Without some further information,...
Car keeps stalling and there is a pulling feeling when driving
This is a common sign of a failing throttle position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-throttle-position-sensor). The throttle position sensor (TPS) is a sensor used to monitor the throttle position of a vehicle. The sensor is usually located on the butterfly spindle/shaft so that...
where to go to have a lost key made inexpensively
Your key has a transponder inside of it that communicates with the car's computer allowing it to start, lock and unlock when you are within a specific range of the vehicle. You will need to purchase at minimum a new...
P0300 & p1133
Inasmuch as the car was running fine before the work was done, the likeliest explanation is that the timing was belt was installed out of position, that is one tooth off. Such will cause the engine to run very badly,...
my 2008 yukon was in two accidents in 30 min. i now have codes popping up i have had a check tire monitir system, air suspension a
It sounds as though the trouble codes are probably a result of the accidents. With no warnings prior to them, and now having them on, I can only assume that this was the cause. But, it would be necessary to...
My 2004 acura tsx center control panel lights are off or really dim.
This happens on many cars with some age. Unfortunately the only way to resolve this issue is to replace the entire control unit in the center console. This is because the lights that light up this part of the dash...
I have a 95 Nissan Truck, short bed XE, 2.4 liter, 2 wheel drive. About a year or more the check engine light came on. Code:43.
Hi Aaron. Thanks for contacting us today. A damaged throttle position sensor can cause a lot of issues, including the one you have mentioned. However, it's also possible that other, routine maintenance problems like clogged fuel injectors, dirty EGR valve,...

Related articles

A Buyer’s Guide to the 2009 Mazda Tribute Hybrid
2009 2009 marked the end of the very short life of the Mazda Tribute Hybrid. All told, the automaker produced fewer than 700 models, and it was ultimately retired well before the Tribute itself ceased production in 2011. For the...
2012 Mazda CX-5 vs. 2012 Toyota RAV4: Which One Should I Buy?
Mid-size crossover SUVs are an excellent option when you need to take several friends along with you, or bring your kids along and yet still need to keep a tight leash on your purchase cost as well as your ongoing...
The Best Used Cars to Buy If You're a Personal Assistant
As As a personal assistant, you have a lot of demands placed on your time. Often it’s important that you be able to get around town quickly, running a ton of errands, picking things up here, dropping them off there,...