Q: Does the engine need to be lifted forward in order to replace the oil pan gasket?

asked by on September 22, 2016

We have two Pontiac G8 GT with 6.0L engine. Both cars when we got oil change done we have been informed that the oil pan gasket needs to be replaced. We are starting to see oil spots in the garage and the driveway where these cars are parked. My specific question is does the engine need to be lifted forward in order to replace the oil pan gasket?

My car has 148000 miles.
My car has an automatic transmission.

Hi there, thanks for writing in. The oil pan is clear to be removed without lifting the motor. The original pan gasket is riveted to the pan. The new gasket does not need to be riveted on to pan for installation. Hope this helps and best of luck!

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Engine will not stay started.
This may be a problem with the fuel filter or fuel pump. If the fuel pump is getting weak or not working at all, that may cause your issue. If the fuel filter is clogged, this may also cause your...
Shifter linkage not working properly
Hello. If the shifter is stuck in 3rd and 4th gear then most of the time the linkage is the problem. With the engine off you should be able to move the shifter through all of the gears. If not...
froze wheel hub bolts and calipers screw pins
When it comes to frozen, rusted, corroded and seized parts, it will take time, a lot of heat and liquid wrench. From personal experience, I find PB blaster works better than liquid wrench. Try getting the part real hot with...
replaced the engine temp sensor and now the cooling fans wont turn on
Hello there, a few common faults will cause your cooling fans to not work after the temperature sensor was replaced on your 2003 Subaru Impreza. If the problems started right after the repair was made the replacement coolant temperature sensor...
the back passenger floor gets wet nothing else, what is the cause and what to fix?
Hello. Thank you for writing in. The windows have drain tubes and holes that take trapped water from the windows and doors and channels it where it can drain. These drains can become clogged over time with dirt and debris....
Overheated, power steering went out and battery went low
Hi There, What you have described sounds like your serpentine belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) may have come off. As you may know all of the accessories (ie alternator which charges the battery, power steering and the water pump) are driven by the...
How do you replace the passenger power seat switch? Having a hard time taking off the Side panel that holds switch in place..
Remove the bolts that hold on the panel to the seat. Then you may have to remove the bolts that secure the seat to the floor to lift up the seat rail and gain access to the rail bolts to...
My engine light comes on and then my car shuts off. I have a 2012 Chrysler 200
A problem that seems to resolve after the car sits for a while usually points to a sensor failure. Many sensors contain coils of wire that might get an intermittent break that only occurs at certain temps, so it seems...

Related articles

The Best Used Cars to Buy for Occasional Drivers
Not Not everyone relies on their car on a daily basis. Maybe you aren’t the type that deals with a daily commute, and running from here to there constantly. If that’s the case, you may be looking for a car...
How Long Does a Differential Gasket Last?
The The rear differential controls the rear pair of wheels so they can rotate at different speeds, which allows your vehicle to travel smoothly and keep traction on the road. If you have a rear-wheel drive vehicle, you have a...
How Long Does an Exhaust Manifold Gasket Last?
Your Your exhaust manifold requires a seal between the cylinder head and the exhaust manifold. This seal is called the exhaust manifold gasket, and is an incredibly hard-working part. The exhaust manifold is where all the engine cylinders’ burned gasses...