How to put my pulleys back on and my serpintine belt on a...
Responses
Customer
394 days ago
Ok thanks
Paul M ASE Master
394 days ago
Hello and welcome to Just Answer. I'm Paul, I will help you with your question today.
I am attaching your belt routing diagram below:
[https://peapull.com/o/1599157731.pdf](https://peapull.com/o/1599157731.pdf)
If you need more help just reply, and let me know. When you are satisfied with my answer please remember to rate my answer. Positive feedback is also appreciated.
Thank you,
Paul
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
Ignition clicks but won't turn on
Hi there. If the engine was starting to vibrate and will no longer start then you can have a number of issues occurring. It can be anything from a failing sensor to a timing chain problem, which is common on...
Car not shifting out of park
Your car uses a shift interlock that keeps it from coming out of park unless the brake pedal is pressed. If the brake light switch fails or if the locking solenoid fails then this will occur. The most common failure...
All wheels are slightly bent and one wheel is cracked
When the vehicle's rims develop these type of cracks, they should be replaced immediately (https://www.yourmechanic.com/article/how-to-buy-good-quality-rims). The cracks can make the wheel unstable and should not be driven on until it is repaired. The most common causes of trims cracking in...
check engine light is on -- ge -ot a diagnotics test from onstar -- test stated emmissions system issue whatdoes this mean
Hello, thanks for writing in about your Chevrolet Malibu. If they did not give you the trouble code that is stored then you are going to need to have the system tested to see if the code can be diagnosed...
replaced brake shoes in the back (they are drums,) but now they dont work...
Hello there, thank you for asking about your 2001 Ford Escape. You may have put in a spring incorrectly or did not adjust them tight enough before putting on the drum. If you think there is a missing spring then...
I am having a chirp/squeak sound coming from my rear end
Hello, thanks for writing in. If the problem occurs as the wheels are spinning then it typically means that something is rubbing. Most of the time this comes from the braking system. It is common for the rear brakes to...
Turn signals and hazards don't work 2005 Pontiac Grand Am
Hello - the problem you are experiencing is a failure of the turn signal/hazard warning flasher unit (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-hazard-turn-signal-flasher). The flasher unit performs the flash function for both your turn signals, and the emergency hazard flasher function. I recommend a turn...
I have an very bad oil leak.
The crankshaft seal (https://www.yourmechanic.com/services/front-crankshaft-seal-replacement) is in the area you are referring to. The crankshaft seal lasts maybe 100,000 miles or so. There are other gaskets and seals in that area that would have to be examined as well. If you...
Can you give me an idea what it cost for the brake pads, rotors, calipers and brake hoses on my 2008 Mazda Tribute
Hello. The cost of the repair will really depend on the amount of work that needs to be done. I would also need to know if that price he gave you was for parts and labor or just parts. If...
Browse other content
Services
Cities
How to put my pulleys back on and my serpintine belt on a 2008 2.7 dosge charger ...
How to put my pulleys back on and my serpintine belt on a 2008 2.7 dosge charger