☰
GET A QUOTE

Q: Cranks but will not start

asked by on September 20, 2016

I have a 2003 Chevy Malibu that i took out of storage after 4 years. Drained fuel tank and added fresh fuel. Tried to start car, would crank, but no start. The car is getting fuel { fuel pump pressure is 52 lbs with key on}. Checked for spark on no. 2 cyl. no spark, but have not checked any of the connectors on the coil packs yet. The manual also says too check fuses { which ones.}. The car was running fine before i took the battery out and put it in storage

Recommended Services

Crankshaft Position Sensor Replacement $120.83 - $900.50 Get a Quote
Car is not starting Inspection $94.99 - $114.99 Get a Quote
Or For Any Other Auto Repairs Get a Quote

As you already know, I would suggest testing the coil packs for spark. Try also checking the crank position sensor to be sure it is working properly. When these go bad they can often cause the coils to not produce any power to the plug wires. If you’re unable to pinpoint the issue yourself, consider YourMechanic, as one of our mobile technicians can come to your home and diagnose your starting issue firsthand.

Chevrolet
Sensors
Malibu
ignition system
2003
V6-3.1L
no start
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Engine steaming, smoking, and smelling.
The problem you describe is a blown leaking coolant hose or one of the cooling system components have started leaking. The strange smell may be the coolant burning off. This is a sweet smell. The cooling system has a leak...
Read more
How do I turn on the sound system?
To turn on the sound system, simply press the power button. Press the button again to turn off the sound system.
Read more
engine wont restart when hot, no spark P0340 has 12v on both connectors, freq from 5-11hz when cranking
Since the crank position sensor gets its timing signal off the damper, I would first replace the damper to be sure timing was correct. The fact that this failure occurs after a "heat soak" cycle, and the P0340 code is...
Read more
Advancetrac light is on no power steering not working
Hello, thank you for writing in. The vehicle may be having issues with the electric power steering module and system. Luckily there is a check engine light on, which means there is an engine diagnostic code that has been set....
Read more
question
The security system warning light should not illuminate once the vehicle is started and you are driving. If the light does illuminate, that means there is a malfunction in the security system. Obviously, if this problem started immediately after you...
Read more
what is that rickety noise my car makes?
Hello, thanks for writing in. There are a lot of components that will make strange noises on the vehicle. The best thing to do is have someone diagnose the sounds, or attempt to narrow it down yourself. The best way...
Read more
My truck is smoking, shaking and leaking some type of oil. What's wrong now?
Check the engine oil level. If there's a sizable oil leak and if the smoke is due to oil leaking onto the manifold, the oil level could be low. If the level is low and you suspect a leak, just...
Read more
my car jerks and seems like it wants to shut down when im at a red light and i roll the windows up lights seem to dim out
This sounds like it could be two separate problems. You may have been on the right track with the battery, but if the voltage drops while the engine is running, that sounds more like a charging system problem. It might...
Read more
the sliding door lock in frozen in the locked position is this an indicator that the actuator needs replaced?
There is a motor in the lock actuator. Premature wearout of the motor is a known reported issue. The testing consists of ensuring that power is being delivered to the actuator, that is ensuring that the electrical connections to the...
Read more

Related articles

Symptoms of a Bad or Failing Starter
Common signs include the engine not turning over, starter engaging but not spinning the motor, and grinding noises or smoke when starting the motor.
Read more
How to Replace an Air Cleaner Temperature Sensor
The air cleaner temperature sensor allows the computer to adjust engine timing and air/fuel ratio. A rough idle or "engine lag" are signs of failure.
Read more
How to Adjust Timing on a Car
A well timed ignition will allow the engine to run powerfully and efficiently. The timing needs adjustment when the engine runs too lean or too rich.
Read more

Browse other content

Services
Estimates
Cities
Maintenance