I need to remove and install a passenger side sun vissor ...

Customer

I need to remove and install a passenger side sun vissor for a 2012 chevy sonic ...

I need to remove and install a passenger side sun vissor for a 2012 chevy sonic

Read More

Responses

Nachum Wagschal

231 days ago

Automotive Expert

Good Morning , Let me see if i can find you some instructions for this

Customer

231 days ago

thanksneed instructions

Nachum Wagschal

231 days ago

Automotive Expert

Here are the instructions , it looks like pretty much 2 screws a couple plastic clips to squeeze and electrical connection

Still not sure what you need?

Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.

Get a Diagnostic

Top Questions

Trending Topics

What others are asking

My car is not driving smooth as I feel hard acceleration but only at low speed i.e 40 km/hr

Hi there. This presents an interesting situation and I completely understand how you feel. It's almost like now that something has gone wrong, you wonder what else is going wrong with the car? And it doesn't feel like it should....

Second opinion on a front lower control arm issue.

Hi there. I seriously doubt that both or either lower control arm is broken; if that was the case you wouldn't have been able to drive your vehicle to another shop for a second opinion. My best guess would be...

ECU Compatibility

The part number for the 3.5L 6-cylinder engine is 8966142G02 and the number for the 4-cylinder engine is 8966142F72. As long as the ECU you're getting matches or cross references the appropriate part number, there shouldn't be a problem. However,...

Isuzu kb 280.sound that appear to be from engine.but worsened when we removed the gear box to replace rear oil main oil seal.after

Hi there. The sound that you are hearing is the clutch clicking and not engaging. One of the pressure plate springs has broke causing the noise to appear under a load. This could have happened the last time that the...

Stalls on acceleration, must feather the gas pedal to increase rpm's to keep from stalling

It sounds like the ignition timing may be off a bit especially if you hear a pop noise when you do try to lean into the throttle too quickly. A timing light can be used to check the timing to...

When pressing gas pedal car starts to shake then stops when i let go

Hello, thank you for writing in. Due to the occurrence of your symptoms being related to the acceleration of the vehicle, it is likely that the vehicle is misfiring for one reason or another and causing an engine vibration. Misfires...

My housing holes on my 2013 chevy Cruze bust and overheated now it will not start

Anytime an engine is overheated then you may damage internal engine components. Since you state the engine is seized then you may have blown a head gasket and one of the cylinders are full of coolant causing the engine to...

Hi there. What you are describing tends to occur when either an oil line becomes loose or internal engine damage occurs. However, it's also possible that you have an electrical or ignition system component failure that is causing the hard...

Car hesitation while accelerating/highway speeds

Hi Miko. Thanks for contacting us today. The first thing I would do is download any stored OBD-II trouble codes in the ECU. This might lead you to your random misfire issue. I wouldn't suggest replacing any sensors until you've...