Q: Car overheating/fluctuating on temperature.

asked by on December 26, 2016

When I'm driving my car with the heat on(i work graveyard shift, so it's cold out), everything will be fine, until my RPM's drop below 1,500. Once that happens, the heat slowly goes away(getting colder and colder) and the temp needle on my temp gauge(Engine temp?) starts to go higher and higher. Once I start going above 1,500 RPM's(whether revving the engine, or accelerating/driving at higher speeds)the heat returns from the vents, and the needle goes down. Furthermore, once I get to work in the morning, after driving about half an hour(mostly freeway at 60mph), I can pop my hood, and my radiator cap is cold as can be. I have replaced the Thermostat already, no real change. I didn't bleed the coolant, but have burped it once(this resolved the issue for about a week). The car does the same thing at stop signs/red lights/freeway traffic overheating when RPM's aren't up. Temp Sensor?

My car has 168000 miles.
My car has an automatic transmission.

Water Pump Replacement $187.27 - $1236.57 Get a Quote

Hello, thank you for writing in. There are several other components that can cause a malfunction with the cooling system. You are in the right realm of thinking however, and there is likely a bad circulation of coolant or air in the system. Sensors can be an issue and may need to be looked at eventually. Air typically works its way out after a while, and burping the system again can’t hurt it. The water pump is driven by the engine’s drive belts. If the engine decreases in power the water pump will have less power. Typically the engine will compensate for this, however if the pump is failing, there is only so much compensation that can be done. The water pump should be the next component to look into. For more help diagnosing the issue, contact our service department.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Fuel leaking from my engine.
You must have a fuel line that is leaking. Diesel engines have very high fuel pressure. With the age of your vehicle it is very possible that you have a fuel line that has rusted through. This is a pretty...
Air conditioning compressor stopped working
If the compressor was recently replaced and has stopped working then most of the time it is because a fitting was left loose and all of the refrigerant came out or there is a loose electrical connection. It is also...
Check engine light, loss of acceleration, 1 RMP even though stopped, speedometer gauge not working
Sounds like you have done a lot of work on your van recently. It sounds like your vehicle went into failsafe mode causing it to lose power. My suggestion is to have a mechanic, like one from YourMechanic, come and...
shifter stuck in manual mode after accident
Without body damage, it is most likely a coincidence that it is stuck in manual mode. Regardless of how it came to quit working, it should be diagnosed just as any other failure would be. I would begin with a...
Where is the crankshaft sensor located on the 3.6 engine
Hey there. On your 2008 Tribeca Subaru, the sensor is on the rear of the motor near the flywheel side under a protective cover that is accessed after the air intake chamber is removed. If you need help with this...
Check Engine light comes on when cars RPMS go over 4000 error code P0344
Hi there. This code is for a bad camshaft sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement). It can be caused by a bad sensor or it can come from another issue. I usually check the sensor first and then I check the timing belt (https://www.yourmechanic.com/services/timing-belt-replacement)....
My alternator was just replaced. Now it's whining and locking on me! Why?
Check the transmission output shaft housing and make sure that it is not cracked or damaged. The vehicle speed sensor (https://www.yourmechanic.com/services/speed-sensor-replacement) is located in the output shaft housing and controls the speedometer. If the housing is binding with the output...
Is my tire & mag salvageable?
It's not a great idea to run on a flat tire but if you are talking about only literally 100 meters, it is possible the tire is OK. The reason it is newly leaking from the tire bead area is...
Fit a modified AUDI TT oil pump to the car, replaced the oil pressure sensor, but oil pressure light still on! 2005 Volkswagon
Hello - I would first put a real oil pressure gauge (https://www.yourmechanic.com/article/how-do-you-know-if-the-oil-pressure-gauge-is-bad) on the port for the oil pressure switch and see what real pressure looks like before driving it. Low oil pressure light switches trigger at only about 5...

Related articles

A Buyer’s Guide to the 2012 Chevrolet Equinox
The The 2012 Chevrolet Equinox stands out in the small SUV class for its affordable price, its high-powered engine, and its plethora of features. While the Honda CR-V has led this class for years, the Chevrolet Equinox is positioned to...
A Buyer’s Guide to the 2012 Chevrolet Corvette
The The Chevrolet Corvette is an American original that has stood the test of time. With the 2012 version, you’ll discover improved handling and horsepower that delivers the superior performance you’ve come to expect from this icon. With options as...
The Best Used Cars to Buy If You’re an Electrician
As As an electrician, you have to haul around wiring, tools and equipment, and tons of supplies. You can’t get by with a small used car, or even a big one. What you probably need is a good used cargo...