Q: Car is misfiring and has a lack of power

asked by on October 17, 2016

So i just put in a used motor. Pretty much everything is new. When its cold started it idles at 1,000 rpm and dosnt go down until u shift into reverse or drive. When u step on the Gas the rpms drop and chugs and finaly starts moving. I set timing and spark plugs are in order. There is no vaccum leaks.
My car has an automatic transmission.

Engine is misfiring Inspection $94.99 - $114.99 Get a Quote

It is very difficult to definitively say what the issue is. Have you had the vehicle scanned for diagnostic troubleshooting codes? If not, you should start there. Due to your vehicle being pre-1996, the method of receiving codes will be more difficult. You should look to your owners manual for that procedure. Hopefully, the issue will have set a code and will make diagnosis a lot easier.

If this is a misfire, its likely a code is pending. Chances are, this is a problem relating to the air fuel mixture entering the engine when the vacuum changes after entering a gear. If you are certain there are no issues with the vacuum, look to the throttle body, fuel injectors, and valves.

If you need some assistance with these checks, consider YourMechanic, as one of our mobile technicians can come to your home to diagnose the misfire firsthand and help you fix it accordingly.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car not starting, only clicks.
The first thing I would have checked by a certified mechanic would be the battery (https://www.yourmechanic.com/services/battery-is-dead-inspection), a typical battery for your car only has a useful life of about 3-5 years. The amount of power left in the battery might...
Where are the front cupholders?
The front cupholders are located on the center console, in between the two front seats.
Have front wheel drive no rear wheel drive
Hi there. Raise up the vehicle and put it on jack stands. Start up the engine and put it into gear. Watch to see which tires move. Put the transmission in neutral and put the transfer case in 4WD high....
I've had the fuel pump replaced, distributor cap & rotor, ignition control module & crank sensor. Truck still won't start. The
Hi there. Has the battery been tested? Have the battery tested with a digital tester that provides current voltage, cold cranking amps, and state of health. A bad cell in the battery can wreak havoc on the electrical system and...
Do I have a bad fuel pump?
If you have tested the fuel pressure at the test valve on fuel rail and do not get pressure then the system will need to tested for a bad fuel pump.
engine has developed a high pitched whine sound
Hi there. Usually a high pitched sound as you are describing is caused by a bearing, pulley or belt that is worn out. Since there are multiple possible sources under the hood of your vehicle that could cause this noise,...
2001 Lincoln town car signature died when shifted into drive. Rides fine does not due while driving only when slowed to a stop or
The problem sounds like it is due to the transmission torque converter locked up causing the engine to be locked to transmission input shaft. This may due to the torque converter is seized or the overdrive solenoid is stuck open....
Exhaust
The first thing you should have checked is the new muffler and exhaust to see if the exhaust is hitting a body part or a heat shield. This is very common in aftermarket exhaust repairs. I would recommend going back...
The ignition switch in my vehicle is broken. The key won't start the car. How much does it cost to get this fixed? Could I do?
Hi Eliana. Thanks for contacting us today. If you're 100% certain that the ignition cylinder is broken and needs to be replaced, it's best to have a professional mechanic complete this process. While removing the ignition cylinder is not that...

Related articles

P0289 OBD-II Trouble Code: Cylinder 10 Injector Circuit High
P0289 P0289 code definition The DTC P0289 code indicates that the number 10 cylinder is experiencing an above average amount of current at the fuel injector. What the P0289 code means Code P0289 means that the fuel injector circuit for...
P2619 OBD-II Trouble Code: Crank Position Signal Output Circuit Open
P2619 means an issue with the crankshaft position sensor which may cause rough idling and acceleration, engine misfires and poor engine performance.
P0387 OBD-II Trouble Code: Crankshaft Position Sensor B Circuit Low Input
Trouble code P0387 means the PCM has detected a signal from crankshaft position sensor B that is outside the normal variation set by the manufacturer.