Q: Car hesitating and wanting to stall

asked by on February 03, 2016

My car is hesitating and acting like it wants to stall. I had a diagnostic run, after my Check Engine and VSC light came on, and the resulting code indicated that I needed an oxygen sensor replaced.

Car is hesitating and bucking Inspection $94.99 - $114.99 Get a Quote

Oxygen sensor failure is not too common on your vehicle. Just because a code for the oxygen sensor is present, it does’t mean the sensor is bad, just that one of the parameters it reads is out of specification. For example, if you have a code for the oxygen sensor stuck lean, the problem could be a broken vacuum line allowing too much oxygen into the engine. Also, know that on a Toyota or Lexus, VSC will illuminate whenever the check engine light is illuminated. Necessarily, there is not an issue with VSC, just your vehicle demanding prompt attention. I suggest having a qualified technician, such as one from YourMechanic, to properly diagnose and repair your car’s hesitation issue.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Steering wheel shakes when braking
Since you have already replaced the front and rear rotors, I suspect the problem is in the steering or suspension. The first thing that comes to mind is a worn wheel bearing/hub assembly, but other parts of the steering/suspension could...
I had a p0405 get code replaced egr valve, map sensor,mad sensor, and PCv valve just to be safe but still getting the code why?
The code P0405 (https://www.yourmechanic.com/article/p0405-obd-ii-trouble-code-exhaust-gas-recirculation-sensor-circuit-a-low-by-jay-safford) and a rough idle is most likely due to carbon getting into the EGR pintle. This will hold the EGR open. When you are getting the rough idle you should shut off engine and remove EGR...
transmission shifting harsh and/or delayed
The rpm's "skyrocket" is normally an indication of substantial clutch wear within the transmission. Considering the 313,000 miles, this is most likely the case. If the fluid & filter replacement didn't make any change in performance, you should take the...
check engine light on, 1990 Subaru Legacy
Hi there, thanks for writing in about your 1990 Subaru Legacy. You need to have the fuel pressure tested to see if the fuel pressure is within specifications and will hold pressure after testing with engine off. The fuel pressure...
Puff blue smoke on startup
Your engine does not have a PCV valve. The engine is equipped with crankcase vent tubes that do not need replaced or cleaned unless line is broken. You may have valve seals that are leaking oil into the exhaust valve...
Starting problems, starter failure - 1994 Suzuki Sidekick
Hello. Make sure you double check to see if the starter is getting good connections and the cables are good. You may just have a starter (https://www.yourmechanic.com/services/starter-replacement) that is common to only last a few years before wearing out. Make...
Engine misfires and hesitates while accelerating
If the issues only began to occur after the vehicle was fitted with a new MAF and different intake, then it may be possible that the issue is related to the recent work. The mass airflow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) is one...
Hello. My 2005 Dakota makes a loud thud about part of the time half way through braking and sometimes when accelerating.
Check your suspension on your front of the vehicle. It seems that the control arm bushings are worn or damaged and the bolts could be loose causing the suspension to move around when the vehicle is under a load. If...
I have a 2002 Chrysler 300m that had been sitting up for a year. I replaced the rack and pinion but when backing up steering is hard.
Hi there. The issue with the steering being hard seems to be with the pump still having air in it. Start the engine and open the bleed valve slightly. Turn the steering wheel several times from left to right and...

Related articles

A Buyer’s Guide to the 2012 Toyota Camry Hybrid
More More and more manufacturers are offering their most popular passenger cars in hybrid models, and America’s top-selling passenger car is no exception. The 2012 Toyota Camry Hybrid is fuel-efficient, comfortable, and convenient. Key Features The upgraded HSD (hybrid synergy...
A Buyer’s Guide to the 2012 Toyota Corolla
Not Not only does the 2012 Toyota Corolla continue to be one of the best-selling compact sedans in the United States, but it also continues to maintain very high resale values. If you want a car that you’ll get your...
The Best Used Cars to Buy If You're Towing a Boat
If If you’re towing a boat, the vehicle that you buy is largely going to depend on the size and weight of your boat plus trailer. Most cars, realistically, aren’t cut out for the job. We recommend a pickup truck...