Q: Car goes forward when put in reverse backup lights do not come on

asked by on January 09, 2017

Truck goes forward when put in Reverse backup lights do not come on when put in reverse

My car has 180000 miles.
My car has an automatic transmission.

Not able to change gears Inspection $94.99 - $114.99 Get a Quote
Backup Light Switch Replacement $114.44 - $232.01 Get a Quote

Hi there. The most common cause of this type of problem is a transmission sensor, or linkage malfunction or a pressure imbalance in the transmission. With these issues, the car is unsafe to drive until this is resolved. You should have a professional mechanic complete a transmission shifting inspection to determine the precise source of this problem; so they can recommend the right repairs.

Hi there. Check the reverse light switch on the transmission gear selection switch. Look to see if the wires are connected and there is power to the switch. If the switch has no power to it, then check the fuses for any of them burned. If the fuses are good, then there may be a break in the wiring from the reverse light switch to the ECM (computer). If there is power to the switch and no power after the switch when it is pressed, then the reverse light switch would need to be replaced. If you need further assistance with the reverse lights not working, then seek out a professional, such as one from Your Mechanic, to help you.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Check Engine light coming on and car bucking.
A flashing check engine light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is a warning that there is a misfire in the engine that will damage the catalyst in the exhaust. The catalyst is what cleans up the exhaust emissions that come out of your engine....
Sunroof not working.
If the clutch pedal goes down without engaging the clutch. The fluid level needs to be checked in the clutch reservoir. If the level is good then there is a bad seal on either the master or slave cylinder. If...
Radiator hose rubbing pulley after minor accident
Thanks for inquiring about your vehicle. A collision specialist needs to examine the vehicle and YourMechanic does have specialists who could perform a mobile examination and arrange repairs. To save you some money initially you might attempt to contact a...
Car won't start, but it still has stereo on
Hello. If the stereo is on then the vehicle should have some power but the battery (https://www.yourmechanic.com/services/battery-replacement) should still be load tested. It is common for the battery to have just enough power to provide some power but not enough...
Car will start but will not go into drive or reverse. It revs up just fine, transmission was not slipping. Rear tire was covered in fluid.
Hello. I would need to know what kind of vehicle this is to be able to help you with specifics. From what you are explaining though it sounds like a transmission failure. When there is a transmission problem the vehicle...
Lights
Depending on the vehicle you have you may just have the interior light control switch turned on at the headlight combination switch. You may also have a more serious problem like a bad lighting control module shorted and keeping the...
Can a bad ignition coil cause a p0335 and a p0340
If you request a no start diagnostic (https://www.yourmechanic.com/services/car-is-not-starting-inspection) the responding certified mechanic will identify the root cause of the no start and get this resolved for you promptly. The two codes that you note do not normally implicate the ignition...
how to fix a 2010 ford fusion rear parking aid inop
It is very possible that one of the rear parking sensors could be the cause of this issue. However I would recommend having each sensor tested individually to determine which one is faulty before just replacing them all. Ensure that...
PO300 Code. Cause of misfire
Exhaust leaks are not typically a cause of misfiring. However, intake manifold leaks can cause misfiring. Random misfiring (P0300) has lots of potential causes so you just have to perform a methodical diagnostic. Among the possible causes are faulty spark...

Related articles

How to Buy a Good Quality Reverse Light Bulb
Reverse Reverse lights are a specific category of tail light that only lights up when you are in reverse or when you step on the brakes. Tail lights are one of the most important safety components that you vehicle has,...
Symptoms of a Bad or Failing Fuel Pump Shut Off Switch
The switch may have tripped and must be reset if your engine suddenly stops while driving, has issues starting up, or turns over without starting.
How to Replace a Cruise Control Clutch Release Switch
The cruise control clutch release switch is faulty if the cruise control will not turn off or shuts off automatically while driving.