Showing articles & questions for topic
L4-2.3L Hybrid

Both of the codes you mentioned have the MAP sensor in common. It is possible that the MAP sensor is faulty on your vehicle. When the vehicle's PCM picks up that the MAP sensor is not functioning, it goes into...

You certainly can add your own refrigerant, but be careful to not put too much in. Don't worry about adding oil, that is something you do if you replace components. They sell refrigerant cans (https://www.yourmechanic.com/parts/refrigerant) with a built in gauge...

The starter is above the oil filter and opposite the A/C compressor (on the same "side" of the engine as the A/C compressor). The starter may be obscured by a splash shield that indeed must be removed to replace the...

Hi there. The cost of replacement will vary based on what model the vehicle is and if it is all wheel drive. It will also vary based on where you have it done due to the labor cost and what...

Hello. From what you are saying it does sound like you have a bearing failure. When they fail they will make a growling beginning at higher speed. You will then get it at lower speeds the more you drive with...

Hi. The yellow lamp is likely the Traction Control System warning. It would make sense because the traction control system is directly related to the ABS and brake system. It sounds like your Escape has some braking and stability issues....

If the engine is getting hot then this will happen. I would check the coolant level first. Only check it when it is cold. If it is low then there is a leak and that needs to be fixed. If...

Of course, be sure you have no recourse through the warranty or any other written/contractual agreement you had with the seller. If you have to pay out of pocket, this type of repair can be performed on a mobile basis,...

Hi - Ford ignition switches of this vintage have a chronic problem of failing in this manner. The "center button" connection between the key tumbler and ignition switch wears, and the ignition switch is not moved adequately to complete the...

Hi there. The tire message is coming on saying that one or more of the Tire Pressure Monitoring Sensors (TPMS (https://www.yourmechanic.com/services/warning-light-is-on-inspection)) is not communicating to the ECM (computer). Either the sensor needs reprogrammed or replaced. Billing question sent to CS...

I am working on this