It sounds like your 2002 Honda Passport may have an issue with its gear selection sensor (https://www.yourmechanic.com/services/transmission-position-sensor-switch-replacement). This sensor provides information to the powertrain control module as to which gear the vehicle is in. If this sensor is giving false...
Hello, thank you for writing in. Considering the age and the mileage on the vehicle, it is not impossible for a few of these components to be going out at once. If the check engine light remains on, you will...
The “check fuel fill inlet” warning light means that there is a problem with the fuel tank cap seal. The fuel cap could be missing, loose, damaged, screwed on too tightly and thus distorted, there is debris in the fuel...
The Code refers to the dual stage oil pump that your car has. One reported fix has been to simply use the OEM (dealer supplied) oil filter as opposed to aftermarket filters. Among the other possible causes of the code...
Hi...Diagnostic Trouble Code P0016 (https://www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) has many causes other than a failed camshaft position sensor. Other possible causes for Code P0016(https://www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) to set include: the camshaft timing is wrong because the timing chain jumped teeth; the camshaft phaser is out...
It is possible that the issue could be related to your throttle relay. The throttle relay would be located in your power distribution box under the hood. I would recommend swapping it with a similar relay to determine if the...
Without more information, it will be difficult to estimate the price of the service on the car, but it looks like this diagnostic trouble code (DTC) P003B, is related to the vehicle's turbo charger, which may need service or replacement....
Hello there. Typically jump starting a vehicle doesn't trigger an OBD-II error code. However, one of the most common misdiagnosis issues with the P-2270 (https://www.yourmechanic.com/article/p2270-obd-ii-trouble-code-o2-sensor-signal-stuck-lean-bank-1-sensor-2-by-jay-safford) is replacing the O2 sensor before diagnosing if there are any exhaust leaks. Obviously, you'll...
There are a couple of places to start looking. The proper fuel pressure is required for good performance and a technician can check fuel pressure to see it if is low which will point to a clogged fuel filter or...
Hey there. I would recommend letting them diagnose the problem rather than just simply telling them to replace the fuel pump. The vehicle is under warranty (https://www.yourmechanic.com/article/how-to-use-your-car-warranty-successfully-by-patrick-haas) since it is a 2016 model. For Hyundai warranty to pay the dealer...
Hello, thank you for writing in. If you are receiving a code for the camshaft position sensor, it is likely causing your loss of power. The vehicle must know where the camshaft is to calculate other engine functions accordingly. A...
The code P0977 (https://www.yourmechanic.com/article/p0977-obd-ii-trouble-code-shift-solenoid-b-control-circuit-high-by-brady-klopfer) will set if the transmission control module (TCM) records an abnormal voltage reading from a shift solenoid in the transmission. A vehicle with the P0977 trouble code will generally be driveable but due to the potential...
A real shop would perform a 75 point inspection (https://www.yourmechanic.com/services/75-point-safety-inspection) while the car is in their care. If they see that you need tires and struts on the second approach, then they are not a real shop. The noise that...
Diagnostic Trouble Code (DTC) P1273 sets if lean operation is detected. There are quite a few causes but if you have already replaced the oxygen sensor, the ECM has to be cleared of stored "self-learned" mixture ratios, and the DTC...
The intermittent illumination of the Check Engine Light (CEL) should be resolved by getting a CEL Diagnostic (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) and then repairing the fault that is identified. Such a diagnostic might provides clues as to the other faults you are writing...
The system requires the brake lights to turn on to unlock the shifter. If you check the brake lights and the lights do not come on then check the brake light fuse (https://www.yourmechanic.com/services/fuse-replacement) to see if it is good. If...
Hey there. It sounds like you may have a major electrical issue with your vehicle. This could be a short of some kind or a computer going bad. I would recommend enlisting the assistance of a qualified professional who is...
If you visited a smaller local repair shop or a garage chain, you may want to take the car to the dealer where they have the proper equipment to extract the fault coes from the system. These mechanics are specialized...
A failure of the electrical system can come from a loose or broken connection at the battery or an alternator failing to maintain the charge. You may want to hire a second source for another opinion and maybe another estimate...
Hello. It is a common issue for the ABS control module to go bad on these trucks. Either the modules are ridiculously expensive or they just aren't available anymore. That is why the connector was unplugged. That is the "cheap"...
