EVP Shut Off Solenoid Replacement at your home or office.

Our certified mechanics come to you · Backed by our 12-month, 12,000-mile warranty · Get a fair and transparent estimate upfront


EVP Shut Off Solenoid Replacement Service

What is the EVP Shut Off Solenoid all about?

Your vehicle is equipped with an emissions-related system known as the exhaust gas recirculation, or EGR. Its purpose is to reintroduce exhaust with unburned fuel back into the engine to complete its combustion. The system is controlled by a valve that determines when to allow exhaust gases back into the intake air and how much to recirculate. This EGR valve has a position sensor that determines what position the gate is in to allow exhaust gases into the intake. This EGR valve position sensor (EVP) has a solenoid that closes the gate to prevent any exhaust gases from entering the intake. This shut off solenoid closes the gate during engine warm-up in particular so the engine can reach operating temperature easily and optimally on fresh air alone.

If the EVP shut off solenoid doesn’t close fully, the engine can experience difficulty starting or may run rough on a cold start. If the EVP solenoid doesn’t open when the engine reaches running temperature, the emissions system will not run efficiently and excessive hydrocarbons will be introduced into the atmosphere.

Keep in mind:

  • The EGR system is part of your vehicle’s emissions control system and needs to be functioning in most areas for smog tests.
  • Exhaust systems are extremely hot and should not be touched until they have completely cooled.

How it's done:

  • The EVP shut off solenoid is verified it needs replaced
  • The defective EVP solenoid is removed
  • The new EVP shut off solenoid is installed
  • The engine is scanned for codes
  • The vehicle is road tested for proper operation and no check engine light comes on

Our recommendation:

The EVP shut off solenoid does not require regular maintenance or servicing. If your engine light comes on or you experience an engine knock, it may be related to the EVP solenoid. Have one of our expert mechanics diagnose the concern and replace the EVP shut off solenoid if necessary.

What common symptoms indicate you may need to replace the EVP Shut Off Solenoid?

  • Engine knocks while accelerating
  • Check Engine light is on

How important is this service?

If you are experiencing engine performance issues related to your EVP solenoid, have it replaced before additional engine damage occurs, such as burnt valves. Alternately, replace a faulty EVP shut off solenoid before a smog test.

Fast and easy EVP Shut Off Solenoid Replacement service at your home or office.


Recent articles & questions

How Long Does a Points & Condenser Last?
Your Your engine uses air and gasoline to operate. However, it needs to combust that gas, which means it needs a spark. Sparkplugs are used for that purpose, but they must get their power from somewhere. In newer models, ignition...
How to Replace a Lost or Stolen Car Title in Kentucky
It’s It’s an exciting day when you finally pay off the loan for your vehicle, or maybe you’re lucky enough to have saved enough money up front that you can pay for it in full. Whatever the route you have...
Windshield Laws in Oregon
Motorists Motorists in Oregon are required to follow numerous rules of the road, but there are also additional traffic laws of which they need to be aware. In Oregon, driving a vehicle that does not have the proper equipment, or...

Keep stalling when I slow down or shift gears

Engine stalling is typically caused by fuel or ignition system problems and/or faults in the air induction system (including vacuum leaks) and engine management sensors. If you request an engine stalling diagnostic (https://www.yourmechanic.com/services/car-is-stalling-inspection), the responding mechanic will go through a...

Driving downhill my Traction Light and ABS light came on. 2009 Buick LaCrosse.

Hello. The traction light and ABS light are like a check engine light for your braking system. If an issue is detected the light will illuminate and code will be stored inside of the ABS module. I suggest that a...

My a/c isn't blowing cold air.

The belt has to be on the compressor for the system to work. If you haven't already done so, installing a new belt will be a good first step and it may solve all your trouble. But if the air...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com