Q: Won't go over 35

Some signs that a tune up is needed include, rough engine idle, hesitation during acceleration, and poor fuel economy. A tune up on your particular vehicle would include spark plugs and an induction service. The induction service would remove the carbon...

The Check Engine Light will come on for a number of reasons. Since the light is on, I would start by scanning the computer for codes. The codes will help to isolate the problem. If the light is flashing, then...

The left rear bulb would need to be checked to see if it is bad. It's possible that there could have also been a blown fuse or a short that has occurred. A technician will be able to inspect your...

Many engines, regardless of the mileage, will burn a little bit of oil over time. This is part of the reason that the manufacturers recommend changing your oil at certain intervals (https://www.yourmechanic.com/article/when-should-i-change-my-oil). If your vehicle was due for an oil...

They may cause some sag in the rear suspension but if you word the inside of tires, then you have worn bushings on the lower control arms and possible weak springs and struts. Have the entire suspension inspected and have...

You should mainly do the oil and filter (https://www.yourmechanic.com/services/change-oil-and-filter) change. The rest of the maintenance is as needed when inspections are done. Some examples of other components that need to be maintained include: air filters (https://www.yourmechanic.com/services/air-filter-replacement), wiper blades (https://www.yourmechanic.com/services/windshield-wiper-blade-replacement), lights...

Hello. The lower joint carries most of the load and wears out first, but both upper and lower will have wear and may both need to be replaced. If you jack up the front end and support from under the...

Hi, thanks for writing in. The temperature of your heater is going to depend on the circulation of the coolant, temperature of the engine, and the associated parts working correctly. The blend door actuators, level of coolant in the system,...

Hi there. From the description you have provided, the vehicle you are working on needs further diagnoses. First, 100 PSI for cylinder compression is inadequate. I would look into whether valve timing is correct. An incorrectly timed camshaft (https://www.yourmechanic.com/services/timing-belt-replacement) could...