The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
I would take it to the dealer and have them diagnose it some more there are some common whining noises coming from that car. It could be in the transmission, the wheel bearing, drive shaft, fuel pump or something else....
Hi there, it sounds like your pads are rubbing against the rotor creating excess heat. Normally the pads release slightly off of rotor when the brakes are released and the wheels start moving. If the issue is still happening after...
If you are not getting any spark, a few things I would check would be the ignition coil or coils (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse), the ignition module, the ignition system fuses (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse), and finally the cam (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-camshaft-position-sensor) and crank position sensors (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor). Tests...
This may be a sign of a failing mass air flow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement). The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected into...
Installing a thermostat (https://www.yourmechanic.com/services/thermostat-replacement) upside down will cause the engine to overheat. Although not impossible, the thermostat will fit better one direction than the other. The coiled or spring loaded end needs to go into the engine block. The end...
Hey there. Your son's car has something called a constant velocity (CV) joint (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement) which is essentially the drive axle that transmits power from the transmission to the wheels. These CV joints have rubber boots that surround them to keep...
Hi Elizabeth. Thanks for contacting us today. I've forwarded your inquiry to our sales and service department so they can determine if we're able to replace the knock sensor of your 2002 Toyota Highlander. They should be contacting you via...
Check the level of engine oil to be sure they actually added oil. Check to be sure the gas cap seal is in good condition and the cap is secure (a loose cap is a common cause of a warning...
A significant portion of the cost of the repair is the labor to gain physical access to the clutch mechanism (the engine and transmission have to be separated). Therefore, if clutch components are contaminated or worn, once the effort has...
P2274 P2274 code definition O2 (Oxygen) Sensor Signal Stuck Lean Bank 1 Sensor 3 What the P2274 code means This code definition indicates that either the oxygen sensor has failed, there is an exhaust leak before the sensor, or the...