Q: Where are the safety labels located?

Yes, that is what they are for. A lot of German cars have them. They are made so that you can jack them up (https://www.yourmechanic.com/article/all-about-car-jacks-and-stands) at these safe points and not worry about anything bending or slipping. That's where you'll...

Hey there. The symbol you are describing is for a problem in the transmission. The transmission can have several issues such as slipping problems, hard shifting, stuck gears, or internal damage. If you need a diagnosis of the warning light...

Hey there. In general, "yes", you can do this. Most automatic transmissions allow this, within limits of acceptable engine speed. But this will accelerate transmission internal clutch wear, with shock loads on the axles, CV joints, engine, and differential. Modern...

The harmonic balance does not have a bearing in it. There are various tensioner pulleys in your serpentine belt system that do have bearings in them that can cause this type of grinding sound when they are worn out. I...

Hello. In most cases the vehicle's traction control system is on a completely separate circuit then that of the engine knock sensor. Therefore most knock sensor faults or issues should have little to no effect on the operation of the...

Hello. I have seen this quite a few times on this vehicle. If the vehicle is all stock then the issue is usually in the rear junction block for the wiring under the rear of the vehicle, or a problem...

Hi There, It sounds like you may have a problem with the vent valve solenoid (https://www.yourmechanic.com/services/evaporation-vent-solenoid-replacement) in your evaporative emissions system. Normally the vent valve is open. It closes when the engine computer tests the EVAP system for leaks. If...

You may have problem with the transmission or throttle control and will need to have the computer tested for fault codes that will point to the possible fault and lead to further testing to pinpoint the cause. You may have...

Hi Kent. Thanks for contacting us today. Unfortunately, internal engine rebuild service is not one our mobile mechanics offer. Installing new pistons, rings, connecting rods and others requires machining the engine block first, which is something that should be done...