Q: Wheel stud broke

asked by on

One wheel stud broke, and the other one is stripped.

Wheel studs will usually do this if they are cross threaded when they are installed or if they are over torqued. In order to replace your wheel studs the brakes will need to be disassembled to remove and replace them.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Wheel stud broke

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Driver side headlights are dim. When I flash brights, the engine dies.

Hi and thanks for contacting YourMechanic. First check the battery cables for a clean and corrosion free contact. If the battery is good, then there is a problem with the wiring in the steering column. There is a short crossing...

Q: Q: car won't start

No starting conditions are the most common fault found in automobiles. With the car sitting for a month it increases the possibilities of potential faults that prevent the vehicle from starting. The most common causes would be the battery, fuel...

Q: front passenger wheel locked up.

Hey there, thanks for writing in about your 1989 Chevrolet K1500. You say it may be the axle so I guessed you have a 4x4 vehicle. You will need to isolate the axle to see if the wheel bearing in...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
What Causes Hoses to Leak?
While the largest part of your engine is mechanical, hydraulics plays a significant role. You’ll find fluids at work in a number of different areas. Your car's fluids include: Engine oil Transmission...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...