Q: What is the cost for water pump replacement

Hello. The high pressure power steering hose is the most common hose to leak on your vehicle. I have also seen the return line leak at the power steering reservoir from a loose clamp. If the leak cannot be easily...

There is specialized equipment for finding leaks in AC systems. One way is to add a fluorescent dye the the system, run the system, and check for a leak with a black light. There are also electronic tools to detect...

Your vehicle uses an electronic throttle instead of a conventional throttle cable. In this system, the control module receives a signal from the accelerator pedal position sensor. The module then uses this information to control the motor to adjust throttle...

Hi There, It sounds like you may have a sticky thermostat or potentially a cooling fan that may be working intermittently. The thermostat regulates the flow of the coolant in your car's engine and controls when the coolant flows in...

Have a certified technician look into the transmission fluid leak (https://www.yourmechanic.com/services/transmission-fluid-is-leaking-inspection) as soon as possible. A number of faults can cause the leak. Seals are certainly among them, Output shaft seals, front pump seal, etc, Even the transmission pan seal...

The alternator is not used in starting. However, a faulty alternator will not keep the battery properly charged. The starter may click if the jump start connection at the battery is poor or the starter may click if the starter...

What you are describing sounds like a failing CV joint (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement). A CV (Constant Velocity) joint is a shaft that connects the transmission to the wheels, essentially transferring the power from the drive train directly to the wheels. The CV...

Check the engine temperature gauge. If the temperature is in the normal (usually mid-way) range, then the vehicle is not overheating. If the vehicle is running hot, though, you can request an engine overheating diagnostic (https://www.yourmechanic.com/services/car-is-overheating-inspection) and the responding certified...

A misfire on a cylinder after you have replaced the plug, coil and injector can be caused by a cylinder problem like low compression or valve train problem or injector wiring or computer issue. You should have injector connector checked...