Q: What if the head restraint is unable to lift or remove?

There are two different 3.0 engines for your Sable: SOHC, or DOHC; single overhead cam, or dual. The timing cover is a big job on either, as there are a lot of parts that need to be removed in order...

Yes, that sounds about right. The price for a fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) and connector to the pump is normal for your Chevrolet Cobalt. The gas cap (https://www.yourmechanic.com/services/gas-cap-replacement) is a common problem also. Best of luck.

Since the noise appears to occur while turning, I would have your mechanic check for a loose or failing accessory drive belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) (often called a 'serpentine" belt). Turning puts more load on this belt, and it may be slipping....

Hello and thanks for contacting YourMechanic. The trigger for your ignition system lies within the computer system. Your computer is not allowing the ignition to trigger the power. The coil should have power to it and a ground wire. The...

Hi there. Assuming, proper procedure was followed replacing the head gaskets. The original cause for overheating must of been overlooked. The thermostat stuck closed (https://www.yourmechanic.com/services/thermostat-replacement), the radiator restricted (https://www.yourmechanic.com/services/radiator-replacement), the radiator cooling fan(s) inoperative (https://www.yourmechanic.com/services/cooling-radiator-fan-motor-replacement). The cylinder head and/or cylinder...

Engine misfires can be caused by a list of problems, but there are a few suspects that occur more than others. Generally, misfires are caused by either a spark or fuel issue, or in some cases a combination of both....

Hi there: Well, the dealership is partially correct here. The P2647 OBD-II trouble code indicates (https://www.yourmechanic.com/article/p2647-obd-ii-trouble-code-system-too-rich-bank-1-by-andrew-quinn) that the powertrain control module has detected a malfunction in the intake camshaft rocker arm actuator system (A). This code is usually found in...

If the bolt threads are stripped and the hole is enlarged for the timing chain guide bolts then you will need to install a thread repair insert. You will have to follow the thread repair kits instructions by drilling out...

Hi there. Get a digital ohm meter and check the resistance on the coolant temperature sensor (water thermal sensor). You are looking for readings that are more than 200 ohms in variance between a cold and a warm engine. If...